Solutions To Deal With The Brass Pool Cover Anchors

1
Welcome to vatsalya
2
Solutions To Deal With The Brass Pool Cover
Anchors
There are 1 out of 2 of the brass covers which
can come down or which cannot go up and just some
of them can actually spin in the hole. Let's
discuss on the top 2 problems that occur with the
brass pool cover anchors. They are as follows
3
The Hex Key Hole Is Stripped Smooth
If you are considering the hole where you are
required to put the hex, it is rounded smooth and
you actually have trouble in rotating it into
another direction. So, in order to avoid this
complexity, you must not make the Hex smooth or
also cannot be stripped off rounded. Then, you
need to check that the hole is not half-filled
with the hardened gift.
4

• In that case, you need to use a large flat which
  is a headed screwdriver. But, all of them don't
  have the slots on the either side of the hole.
  Then there is a need to tap the driver on the
  head of the screwdriver into the hex hole, which
  is deep 'bite' into the edges.
• Then you are required to use the pliers to turn
  the handle. If in case, the insert is raised,
  then you need to grab the edge with the help of
  the pair of locking pliers and then the anchor
  can then be turned if that is not seized up.
  This can be removed then the other half of it can
  be replaced.

5
The Pool Cover Anchor Won't Actually Turn

• This can be done by the hardened grit in the
  threads. Or it can be from the other parts of the
  brass pool cover anchors that can be well
  installed with the help of the poorly drilled
  hole.
• In cases, there is a need to twist and bend the
  hex key and that is made stronger with the help
  of the standard 'L' shaped hex key. This can be
  lubricated again and there is nothing heavy in
  this. It can then be helpful in soaking of the
  oil and for atleast 30 minutes.

6

• Then, you need to lubricate it again and the
  anchor then turns before actually sticking it yet
  again. When you turn a stuck pool, then in that
  case, you can actually turn it in only one
  direction.
• This will be helpful in breaking of the grit in
  the threads. If it has been inserted partially,
  then try to grab the edge and make sure it is
  done with the help of pair of pliers.

7
How To Remove The Pool Cover Anchor?

• There is a chip and pry method which is helpful
  in chiseling out the concrete material which is
  around the top of the anchor. This helps in the
  holding of the anchor at the top. In many cases,
  the chip may not be tapped at the head of the
  screwdriver.
• There are also commercial available pool tools,
  which help in the removing the cover anchors.
  Thus, brass pool cover anchors are actually
  beneficial and its covers can be very easily
  removed.

8
Images
9
Contact Us
Vatsalya Metal Industries Plot No. 3619, GIDC
Phase 3, I Road, Jamnagar, Gujarat 361004,
India Sales sales_at_vatsalyametal.com
10
(No Transcript)