Some Things You Should Know About Corrosion Removal

1
Euroblastme Middle East LLC
Euroblastme is the catering to the growing needs
of blast cleaning abrasives and equipment. We can
provide quality products for the blasting and
painting industry in all around Dubai, United
Arab Emirates.
https//www.euroblastme.com/
2
Some Things You Should Know About Corrosion
Removal
Environmental corrosively, metal coatings, and
surface preparation methods are the three
essential factors that are to be considered to
increase the life of metal structures and
components. The most critical factor in
sustaining the appearance, performance, and
durability of coating systems is appropriate
surface preparation. Below mentioned are the most
important things to know about corrosion
removal Dubai.
https//www.euroblastme.com/
3
Pre Paint Presentation
Unprepared Even if the metal surfaces are in good
condition, not preparing them before painting,
deliver an unsatisfactory substrate. Thats
because the adhesion of coatings to substrates
and their long-term performance gets affected by
the level of preparation.
https//www.euroblastme.com/
4
Cleaning
Before mechanical preparation, surface cleaning
is an essential first step. That is because some
surface preparation methods, rather than removing
specific contaminants, spread them over the
surface. Adhesion can be affected if pollutants
like grease, moisture, oil, dirt, and even
soluble salts get confined under the new paint
coating. It may also cause early detachment of
metal coatings from substrates. Mild-detergent
or bleach solutions are one of the most effective
methods for cleaning painted surfaces. Acidic
solutions and alkaline cleaners can also be used
for cleaning corroded metal surfaces.
https//www.euroblastme.com/
5
Water Blasting
Water blasting is another crucial preliminary
step in cleaning metal surfaces before coating
application or other surface prepping methods,
such as abrasive blasting. Since, water
blasting cleaning method is safe, effective, and
eco-friendly, it is best suitable for cleaning
various metal components like vessels, boilers,
storage tanks, and also concrete structures.
https//www.euroblastme.com/
6
Abrasive Blasting
When done correctly, abrasive blasting thoroughly
cleans surfaces by removing rust, salts, old
paint, fouling, and corrosion. This surface
preparation method also creates a surface profile
that improves adhesion. A variety of blasting
materials such as silicon carbide, steel grit,
aluminum oxide, crushed glass grit, glass beads,
etc. can be used, depending on the overall
surface condition and the profile required for
the application of metal coatings. Before
beginning painting and after finishing abrasive
blasting, the surface must be thoroughly cleaned
to remove any bits of dirt and dust.
https//www.euroblastme.com/
7
Priming
Once metal surfaces are spotless and dry,
corrosion-inhibiting primers that fit with both
the substrate material and the finish coat, are
applied to the metal surfaces. Using the right
primer provides adequate protection against
several environmental factors like salty air,
water, and acid rain. For the best industrial
painting services in Dubai, Euroblast-me is the
one-stop-shop to provide you with the best of
your painting project. Reach them out today to
know more about their other services.
https//www.euroblastme.com/
8

• P.O Box . 31230,Dubai,
• United Arab Emirates.
• Email Id info_at_euroblastme.com
• Contact No 971506413802
• Visit Our Website - https//www.euroblastme.com/c
  ontactus.php