Title: How To Pull the Pre-Terminated Fiber Optic Cable? - A Step by Step Guide
1How To Pull the Pre-Terminated Fiber Optic
Cable A Step by Step Guide
2Table of Contents
- Introduction
- Steps for How to Pull Pre-terminated Fiber Optic
Cable - Contact Us
3Introduction
- Optical fibers are considered to be a next-gen
data transmission medium compared to the copper
core ethernet cables. While fiber optic cables
were deemed expensive initially, technological
advancements and mass production brought the cost
down significantly. - In addition to the better data transfer speeds,
fiber optics cables are flexible and can carry
multiple fibers in a single cable. Due to the
sturdy outer cover and protection measures
implemented inside, the fiber optics cable can be
used for both indoor and outdoor installations. - When run outside, the cables can directly be
buried, pulled into the conduit or ducts, or run
aerially across two poles. Yet, the way you pull
the cable can cause structural damage to the
cable leading to operational failure. So it is
important to learn about pulling the
pre-terminated fiber optic cable.
4How to Pull Pre-terminated Fiber Optic Cable
- Now we shall learn about how to pull the
pre-terminated fiber optic cable in a step by
step method. - There are 5 steps to follow to successfully pull
the pre-terminated fiber optic cables.
5Step 1 Inspect the spool
- Most cable manufacturers provide a spool of fiber
optic cable that is pre-terminated as per your
requirements. Always ensure that the cable is
connected to the pulling eye as shown in the
image. - The pulling eye is nothing but a strong cord that
is connected to one end of the optical fiber in a
loop. Those installing the fiber will connect the
loop to the fastener to pull it across narrow
terrains. Ensure the pulling eye socket is not
entangled with any connectors, else they will rip
out at the time of pulling.
6Step 2 Connect the pulling eye to the fastener
- The next step would be to connect the fastener to
the pulling eye socket. - The fasteners one end is connected to the loop
and the other end is connected to the winch or
automated puller.
7Step 3 Add some lubricant to the pulling socket
- Next step would be to add some lubricant to the
pulling eye. - This allows the cable to pass through narrow
ducts or tight areas without any friction
8Step 4 Pull!
- Once lubed, the only thing remaining is to pull
the cable with appropriate pulling tension. - Depending on the elevation, and the tightness of
the ducts, you may need some extra elbow grease.
9Step 5 Remove the pulling socket and check the
continuity
- Now all that remains is to check the continuity.
- And remove the pulling eye socket after
successful installation.
10Reach Us
- Falcon Technologies Inc. specializes in providing
a large portfolio of leading brands for IT,
voice, video, and data network cables and
connectivity products.
Business Details Falcon Technologies, Inc. St.
Louis Office and Showroom Location 2631 Metro
Blvd. Maryland Heights, MO 63043 Phone
314-994-9066 Email sales_at_falcontech.com
Business Hours Office Monday - Friday 730 am -
500 pm CST Will Call / Receiving Monday -
Friday 700 am - 500 pm CST
Website https//falcontech.com/pages/pre-terminat
ed-fiber-optic-cable-assemblies
Source https//www.articleted.com/article/408417/
107101/How-To-Pull-the-Pre-Terminated-Fiber-Optic-
Cable--A-Step-by-Step-Guide