Study Questions Chapter 05

1
(No Transcript)
2
Question. 1, Page 5-4

• The part of the current that flows into the
  propeller is called _____ _____ _____.
• Suction Screw Current

3
Question. 2, Page 5-4

• When a right handed propeller is turning
  clockwise, the boat will go _____.
• Ahead

4
Question. 3, Page 5-4

• On a motorboat, turning the steering wheel to
  starboard gives the boat _____ rudder and throws
  the stern to _____ and turns the boat to _____ .
  
• Right,
• port,
• starboard

5
Question. 4, Page 5-4

• The stern of a single screw boat with a left
  handed propeller tends to go to the _____ when
  the propeller is reversing.
• Starboard

6
Question. 5, Page 5-4

• When a boat's rudder is put over, the stern is
  kicked ____________________.
• away from the direction in which the rudder moves
  

7
Question. 6, Page 5-4

• When backing an inboard, with a single right hand
  propeller and rudder amidship, the stern will
  tend to move to
• Port

8
Question. 7, Page 5-4

• Three mooring lines that may be attached to the
  bow of a boat for dock mooring are ______, _____
  and ________.
• Bow line,
• breast line,
• after bow spring line

9
Question. 8, Page 5-4

• The four lines that may be used as springs are
  
• Forward bow spring, After bow spring, Forward
  quarter spring, After quarter spring

10
Question. 9, Page 5-4

• The mooring line that keeps the boat from going
  ahead is the _____.
• After bow spring line

11
Question. 10, Page 5-4

• To spring into a dock, use a _____ spring, and go
  ahead slowly with the rudder turned _____ .
• After bow,
• Way from the dock

12
Question. 11, Page 5-5

• Getting away from the dock, when the boat is
  being set into it by the wind, generally requires
  using an _____ _____ _____ ______.
• After bow spring line

13
Question. 12, Page 5-5

• Backing on a forward quarter spring on the port
  side, the bow will _____ .
• Go to starboard

14
Question. 13, Page 5-5

• A forward quarter spring line leads forward from
  the _____ to the _____.
• Boats stern,
• Dock

15
Question. 14, Page 5-5

• A 4 to 6 foot long plank hung horizontally on the
  side of the boat and backed with _____ is called
  a _____ .
• Fenders,
• Fenderboard

16
Question. 15, Page 5-5

• By going ahead on one engine while the other
  reverses, a twin screw boat can be _____ .
• Turned in its own length

17
Question. 16, Page 5-5

• A basic principle in maneuvering a twin screw
  boat, is to use the rudders primarily in relation
  to the direction of the _____ _____ through the
  water.
• Vessel's movement