Status of the SHAFT board design

1
Status of the SHAFT board design

• Outline
• The Calibration Board (SHAFT)
• Inputs/Outputs
• Parts of the board
• Electronic schematic
• Status

2
INPUTS_OUTPUTS

• Total Inputs7 NIM, 1 LVDS, 1 ECL

• Total Outputs8 NIM, 4 LVDS, 2 ECL

3
PARTS OF THE BOARD
4
(No Transcript)
5
(No Transcript)
6
DC/DC CONVERTERS
7
(No Transcript)
8
Status of the Design

• Firmware of the FPGA is almost done
• Finish details
• The schematic is almost finish
• Connect signals to the FPGA
• Next steps
• Test the DC/DC converters(3 days)
• Finish the electronic schematic of the board(1
  day)
• Make the Board layout(3 weeks)
• Manufacture the boards (10 days)
• Solder the boards
• Solder 1 prototype at IFAE (7 days)
• Solder the boards at an external company (3 weeks
  or 1 month)
• Start the debugging of the prototype