Machine Tools

1
Can you name any of the tools we have used so far?
Machine Tools
Hand Tools
2
(No Transcript)
3
Finish chiselling out the housing joint and
sanding the rounded end of the base.
MUST be at this stage by the end of the lesson.
4
Find the correct line for cutting the base from
the back. Ask if you are unsure!
5
Cut through the line using a tenon saw.
SHOULD be at this stage by the end of the lesson.
6
Mark out the top of your desk tidy in pencil
using a design you created. KEEP IT SIMPLE!
IMPORTANT You need to allow 120mm from the
bottom of the joint for the flexi-ply front.
7
Have your design CHECKED before you cut it and
cut it using the hegna saw or a coping saw. KEEP
IT SIMPLE!
COULD be at this stage by the end of the lesson.
8
MUST
COULD
SHOULD
RememberITS NOT A RACE! Tidy up and sweep down
the benches as you go.