Banff Academy

1
Banff Academy
Graphic Communication
Department of Technological Education
2
Department of Technological Education

• An Elevation and Plan of a room layout are shown.
• Using the given sizes and start position, draw a
  Planometric view of the room layout (include the
  back wall, side wall and the floor area)
• Do not show hidden detail (DA10)

3
Department of Technological Education

• Start by drawing the Plan at the correct angle.
• In this case the start point is given at ceiling
  level so it is necessary to find out where the
  floor area starts.

• Draw the positions of any furniture etc. on the
  floor area.

4
Department of Technological Education

• Draw the positions of any walls required.

• Include any doors and windows on the walls.

5
Department of Technological Education

• Add any furniture to the Planometric view.

6
Department of Technological Education

• Add any furniture to the Planometric view.

7
Department of Technological Education

• To finish the drawing darken the outlines on the
  drawing.
• Remember that the question asks that hidden edges
  are not shown so some of the lines will be left
  as construction lines.