Title: HCALJetMET Status
1HCAL/JetMET Status
PRS Physics Reconstruction and
Selection HCAL/JetsMET group
- Shuichi Kunori
- U. of Maryland
- 13-June-2002
- http//computing.fnal.gov/cms/jpg/Default.htm
2PRS Milestonesfor DAQ TDR HLT section
- Tasks
- Data production digi - done /
ntuple - half way - Jet energy scale done, but...
- Algorithm for high lumi. same as low lumi
- Rates, CPU tau, SUSY
3Status of Production
- Event Sample
- HLT Sample (QCD jets)
- CMSIM-125 - done
- ORCA6 digi for 2E33 E34 done
- Ntuple production half way, but
- Signal
- H -gt tautau, high mass SUSY
- CMSIM/ORCA6/Ntuple - done
- HF in ORCA6
- Problem- 1) Eta value shifted by ½ tower
- 2) Energy scale 2 off
- Cause- Those were changed in CMSIM,
- but no corresponding changes
in ORCA. - Fix - put a patch in ORCA6 to return
correct eta value - for HF tower (Cell ID) and right
energy for Digi. - Use the fixed version for Ntuple production and
all other ORCA6 analyses.
4Jet Energy Correction
(A.Krokhotine)
CMS125(GCALOR) 10 higher response wrt
CMS120(GHISHA)
5L2 Tau
See A. Nikitenkos talk at the JetMET session on
Wednesday, 12-June-2002 for more detail.
6(No Transcript)
7(No Transcript)
8L2 Calo Tau ID with em isolation
Similar to ORCA5 results.
9L2 Tau IDCalo / Pixel / CaloPixel
10HLT CPU Estimates for SUSY and Taus
(A.Nikitenko)
Pentium III, 800 MHz CPU, Time in ms.
- x5 gain by
- Bart van de Vyver
11Higgs Mass Reconstruction with/without EE
12SUSY
See S.Abdullins talk at the JetMET session On
Wedensday, 12-June-2002 for more detail.
13SUSY Points
14R Parity Violation
15Kinematics
MET
ET (J1,J2)
Multiplicity
16Transverse Mass
17L1 Cuts and Rates
2KHz
18L2 Cuts and Rates
3Hz
19Conclusion
- Production
- Need a fix to the HF problem and complete the
ntuple production for both low and high
luminosities. - Tau and SUSY
- Need rate calculations with full statistics.
- SUSU additional calculation for lower SUSY mass
channels. - Jet and MET trigger
- Rate calculation with full statistics.
- MET rates/efficiency with corrected energy
scale. - New Algorithms for high luminosity
- Fake jet suppression may be needed in HLT, if we
need to trigger, ET(J) lt 50GeV. - Need a study for dijet trigger.
- Is current L2 Jet thrheshold (600GeV) too high?
20Jet Triggers (ATLAS)
(ATLAS Stephan Tapprogge, May 2002)
Need lower threshold and higher rate to tape ?