SAMARIS Creep test - PowerPoint PPT Presentation

About This Presentation
Title:

SAMARIS Creep test

Description:

Sample size 100 mm Diam 60 mm Height. Normal stress 100kN. Temperature 50 C ... 2x9 cores 90mm diam (not 100mm) Layer sawing in order to have. Surface layer ... – PowerPoint PPT presentation

Number of Views:258
Avg rating:3.0/5.0
Slides: 11
Provided by: lpo9
Category:
Tags: samaris | creep | diam | test

less

Transcript and Presenter's Notes

Title: SAMARIS Creep test


1
SAMARISCreep test
  • Meeting at TRL 2-3 March 2005

2
Time schedule
  • Sample reception
  • LAVOC cores December 2004
  • DRI slabs February 2005
  • Test program
  • Sample preparation (coring and cutting) February
    05
  • Density measurement
  • Creep test
  • At 50C February-March 05
  • At additional TC to be discussed
  • Binder information ?

3
Creep test conditions (1/2)
  • European standard PrEN 12696-25
  • Method A uniaxial cyclic compression test with
    confinement
  • Method B triaxial cyclic compression test
  • British Standard BS 598-111
  • Unconfined uniaxial loading test
  • Internal Shell protocol
  • Performed on the NAT
  • Sample size 100 mm Diam 60 mm Height
  • Normal stress 100kN
  • Temperature 50C
  • Pulse time 0.2s loading 1.8s rest

4
Creep test conditions (2/2)
PrEN 12607-25 (confined or triaxial) BS 598-111 (static load) Shell protocol
Sample size D / H 148 mm D 60 mm H 100, 150 or 200 40 to 100 mm 100 mm D 60 mm H
Normal stress 100 kPa 100 kPa 100 kPa
Temperature 40C (typical) 30C 50C
Pulse 1s (0.5Hz) 3600 pulses 3600 s 0.2s 1.8s
5
Sample preparation
  • From LAVOC material Done
  • 2x9 cores 90mm diam (not 100mm)
  • Layer sawing in order to have
  • Surface layer 2x30mm thick
  • Base layer 60mm thick
  • From DRI material Under progress
  • 2 slabs
  • Coring
  • Layer sawing as for LAVOC

6
Preliminary measurements (1/3)
  • Density measurement (for the time being for LAVOC
    only)
  • Require information on mix characteristics
    (density, composition, )
  • Slight difference between base and surface layers
  • Scattering of results (higher for surface than
    base)

Impact of test results
7
Preliminary measurements (2/3)
8
Preliminary measurements (bis)
9
First creep test result for LAVOC
  • Base layer
  • Excellent behaviour
  • Longer test required
  • Surface layer
  • Lower behaviour
  • Breakdown of certain sample

10
Next step
  • Creep test on the DRI material at 50C
  • Further information on mixture
  • Coefficient calculation
  • Binder data (viscosity of fresh binder) ?
  • To be discussed
  • Test at another temperature? Other conditions?
Write a Comment
User Comments (0)
About PowerShow.com