The HFJV setup

1
The HFJV set-up

• Mike Becker RRT
• Clinical Specialist
• Holden N.I.C.U.

2
The HFJV set-up

• Mike Becker RRT
• Clinical Specialist
• Holden N.I.C.U.

3
Where to find the equipment

• Everything you need should be in the drawer under
  the HFJV
• If extra equipment is needed, it can be found in
  the office department storage area
• Additional adapters are also stored on the Holden
  RC cart

4
Departmental Storage
5
HFJV Adapters
6
HFJV Circuits
7
Adapters sizes are 2.5/3.5/4.5/5.5
8
Each HFJV should be stocked with a circuit and
adapters
9
Equipment set-up
10
Take off the protective tubing
11
Expose prongs
12
Slide the cartridge into the circuit cradle
13
Connect the gas out and purge lines
14
Place the waterline tubing into the water pump
15
Latch shut
16
Attach the luer tip water line, always keep the
water line open
17
HFJV box and connections
18
Connect the green jet line to side port of the
adapter/ pressure and purge line
19
Placing the tubing into the jet box

• Be sure to have the pincher value contact only
  the white area of the tubing

20
The HFJV FiO2 is adjusted with the blender
21
Placement of the oxygen analyzer
22
If you have any questionsCall your supervisor