HOW TO MAKE A BOW - PowerPoint PPT Presentation

1 / 13
About This Presentation
Title:

HOW TO MAKE A BOW

Description:

HOW TO MAKE A BOW. BY: REBECCA F. FLORAL DESIGN -3RD BLOCK. 2004. Revised ... MAKE SURE THAT YOUR WIRE IS ... CONTINUE THESE STEPS MAKING APROX. 4-5 LOOPS ... – PowerPoint PPT presentation

Number of Views:870
Avg rating:3.0/5.0
Slides: 14
Provided by: JCC4
Category:
Tags: bow | how | make | make | robbie | size

less

Transcript and Presenter's Notes

Title: HOW TO MAKE A BOW


1
HOW TO MAKE A BOW
  • BY REBECCA F.
  • FLORAL DESIGN -3RD BLOCK
  • 2004
  • Revised by Robbie Buchanan
  • May 2007

2
TOOLS YOU NEED
FLORAL WIRE TAPE
FLORAL WIRE
RIBBON SIZE
SELECTIONS
3
9 40
3
STEP 1
  • CUT OFF A STRIP OF TAPE APROX. 6 In. LONG
  • STRETCH OUT TAPE TO FULL LENGTH

(Un-stretched tape)
(Stretched tape)
4
STEP 2
  • ATTACH TAPE TO WIRE AT ABOUT A 20 DEGREE ANGLE

5
STEP 3
  • HOLD BETWEEN POINTER FINGER AND THUMB

6
STEP 4
  • SLOWLY TWIST WIRE IN YOUR FINGERS WHILE PULLING
    DOWN ON THE TAPE
  • -MAKE SURE THAT YOUR WIRE IS
    TIGHTLY WRAPPED.

7
STEP 5
  • STARTING WITH YOUR RIBBON, NOTICE THAT THERE ARE
    2 SIDES SHINY AND DULL.

(SHINY SIDE)
(DULL SIDE)
8
STEP 6
  • BEGIN WITH YOUR CHOICE OF RIBBON
  • FOLD OVER KEEPING SHINY SIDE TOWARDS YOU.
  • TWIST USING MOTION SHOWN.

9
STEP 7
  • CONTINUE WITH A SECOND LOOP ON THE OPPOSITE SIDE.
    ALWAYS MAKING SURE THAT THE SHINY SIDE IS TOWARDS
    YOU.

10
STEP 8
  • CONTINUE THESE STEPS MAKING APROX. 4-5 LOOPS ON
    EACH SIDE.

11
STEP 9
  • AFTER MAKING TAILS FOR YOUR BOW PLACE YOUR WIRE
    UP THROUGH YOUR FINGERS BETWEEN

12
STEP 10
  • AFTER PLACING YOUR WIRE PROPERLY, GRAB A HOLD OF
    YOUR WIRES AND TWIST THE BOW NOT THE WIRE.

13
STEP 11
  • AFTER Tightening the WIRE, ADJUST YOUR LOOPS AND
    YOUR BOW IS DONE!
Write a Comment
User Comments (0)
About PowerShow.com