How to install Retractable Tonneau Cover

1
How to Install a Retractable Tonneau Cover
2
Open the cover you have bought and read the
manufacturers instructions. Though there are no
extra tools required to install it, but its
better if you cross check.
3
Set the rolling covers canister in the middle of
the truck bed. There may emerge a need to seal
off the gap between the bed and cab before
putting in the canister. It is very important to
place the canister at the right place.
4
Lay down the covers rail on the top of your bed
rails and fix them with the canister. Also make
sure that the retractable cover is in the right
position.
5
Slip the attaching clamps under the cover rail,
until you are sure, it is in the proper locking
position. Construct the clamps as instructed in
the manufacturers layout. Finally, when you find
it in position, bolt each clamp together.
6
Check the size of the rail span if it is at the
front of the bed and rear of the tailgate. In
case the measurements are not equal, place a shim
behind the clamp to maintain proper distance.
Once done with this, tighten the bolts.
7
You can add the water canisters, tubes, pull
straps or any electrical equipments.
8
In the end, test everything and make the required
adjustments. If the system works properly, you
are all set.
9
Contact Us
Tiger Trays Address 123 Hume Highway,
Lansvale, NSW, 2166 Austrlia ABN 94
078 942 426 Phone No. [phone] Email
sales_at_accessoryworld.com.au Website
www.tigertrays.com.au