Doorstep Mobile Repair by Repairbuy

1
Doorstep Mobile Repair by Repairbuy
repairbuy1.medium.com/doorstep-mobile-repair-by-re
pairbuy-6e90171cc6dd
For a successful Doorstep Mobile Repair, you
first need a clean workspace with enough space
on which all tools and smartphone parts have
enough space. A light surface is also an
advantage to be able to see removed screws and
small parts better. Since a hair dryer is often
used to open the cell phone, a socket should be
nearby. When Doorstep Mobile Repair, you must
grounded yourself, for example by touching a
radiator or using antistatic tools such as
tweezers, screwdrivers, etc. to avoid annoying
damage to your cell phone from a sudden
discharge. The defective mobile phone should be
switched off and (depending on the repair and
model) the Sim / SD card tray removed. The
battery should have less than 25 charge,
otherwise damage to the battery during the repair
could cause it to self- ignite. With the tool you
should make sure that you have the right
screwdriver and others such as suction cup,
spudger, metal spatula, tweezers, etc. in good
quality ready. We offer you a suitable standard
tool set for smartphone repairs in our
repairbuy.in shop often cheaper together with
a spare part.
2
In order not to lose the small screws and to keep
a general overview, it is advisable to place
them on adhesive tape and to label the strips.
Arranging the screws and modules on the table in
the same way as they are built into the mobile
phone itself can also make assembly much easier
in the end. Greasy and soiled areas (e.g. from
fingerprints and adhesive residues) can be
easily cleaned with alcohol and a fine cloth or
cotton swab. It is important to clean the areas
where new adhesive strips are attached, for
example for the back cover, to seal the
smartphone as well as possible against protection
and water. By the way Filming your repair is
also a good idea to find out where the leftover
screw belongs ) If you have carefully set up
the workplace, earthed yourself and all tools and
spare parts are ready, you can get started. A
defective display the classic cell phone
damage Whether you sat on it, fell over, or
however you did it the most common cell phone
damage is and remains a cracked display. Very
annoying, but in fact, this repair often has to
be mastered yourself, the level of difficulty of
the repair varies greatly from manufacturer and
model. For some, the entire smartphone has to be
dismantled to access the defective display, for
others, this replacement is done in 15
minutes. If you have to remove the adhesive from
the display frame, you should proceed with care,
as already mentioned. Better to feel at the right
temperature than to hold on for a long time and
cause more damage. Of course, you can blow-dry
stubborn areas at any time while opening the
smartphone and further soften the adhesive. If
the broken display is already very splintered,
you have to remove it from the frame piece by
piece on some models and scrape off even the
smallest residues of adhesive and glass. When
using the spudger or metal tool, take particular
care not to slip and damage underlying elements
such as the motherboard. Simply replacing the
glass is usually much too time-consuming for
Doorstep Mobile Repair, since, for example, the
glass and LCD must be glued with a special
adhesive and then hardened under a UV light.