Versa Technology, Inc'

1
Versa Technology, Inc.

• How-To VDSL PTP

2
Agenda
1. Setting it up in the PBX Room
2. Setting it up on the user side
3. Configuration
4. Notes
3
PBX Room

• Find where the 66 or 110 blocks are as show
  below.
• If the blocks are marked find where it is you
  want to put the End User Solution, Otherwise
• Tone out the line from where you want to set up
  the point to point back to the blocks. (Make sure
  you tone out both 66 blocks. This will be
  explained later.)
• Once this is complete you are ready to set up the
  modem in the phone Room.

4
Modem PBX Setup

• When you have toned out line to both parts of the
  phone system figure out which one goes to the PBX
  and which one goes to the User end
• Get rid of the crossover connect that connects
  those 2 but make sure they are marked so you
  remember where you are to re-punch down.
• Take the wire you are going to connect and punch
  one end down to the PBX side.
• Then get an RJ-11 end and crimp the other side.
  Plug this side into the port marked phone.
• Do the same for the User side but when you crimp
  that side plug it into the line port

5
CPE Diagram
6
CPE
V
V D
66 Block
66 Block
PBX
line
phone
line
phone
Internet Uplink
Gateway
CO
Ex. Room 101
7
User Side is on a 66 Block too

• If the user side is in another room with 66
  blocks then proceed to have the slots already
  toned out.
• If it is connected just using 1 66 block then
  disconnect each side of it. Then plus the side
  that came from the phone room into the line port
  and the side going the other way to the phone
  port to make sure all the noise is filtered out.
  Crimp both sides if it is its own separate line
  it doesn't need to be connected back. If it is 2
  25 pair cables then just punch a line down to the
  empty middle row and plug it in, in said places.
• If the User side is in an end location with a
  phone jack then just plug it from the phone jack
  to the line port and the phone port to the phone.

8
Notes and Problem Solving

• If the room has multiple phones that are on the
  same line you will need to filter out the other
  phones with external filters
• If it is not connecting make sure everything is
  punched down correctly. Always use the white
  colored line on top as a standard so you will
  never flip flop it. Also make sure everything is
  toned out properly
• Make sure you use the correct power supply even
  though other power supplies might work this still
  could cause problems later on.
• Make sure that the electrical outlet on the user
  side isnt connected to an outlet connected to a
  light switch or something of that nature.