Tripod Localization and Sensing Testbed - PowerPoint PPT Presentation

1 / 10
About This Presentation
Title:

Tripod Localization and Sensing Testbed

Description:

Locate one tripod at origin position, define it as the 'origin' ... System can ask tripods to be moved to improve constraints ... Cover more ground by moving tripods ... – PowerPoint PPT presentation

Number of Views:57
Avg rating:3.0/5.0
Slides: 11
Provided by: laboratory7
Category:

less

Transcript and Presenter's Notes

Title: Tripod Localization and Sensing Testbed


1
Tripod Localization and Sensing Testbed
  • Lewis Girod

2
Goals of this effort
  • Develop a system to calibrate locations of
    field-deployed motes
  • Turnkey system
  • Deploy, use, and take down in a day
  • Minimize restrictions on deployment
  • Provide a convenient platform for
  • testing and evaluating new ranging techniques
  • Acoustic channel measurement?
  • Other kinds of sensing experiments?

3
Mote Localization Problem
Motes
Tripods
4
Tripod Design
  • Resource un-constrained design
  • Runs on batteries for 6 hours
  • Four audio channels
  • 4 fixed microphones
  • Omni-directional, 15Hz-30KHz
  • 1 fixed speaker with a reflector
  • 96 KHz / 24 bit samples
  • CPU
  • 1 GHz P3, 256 MB, 20GB Hard drive
  • Runs on 12V
  • Network
  • 802.11 for inter-tripod network
  • MoteNIC to talk to mote network
  • 3-axis orientation sensor

5
More detail
USB 802.11 adaptor
Mica2 Mote
Reflector
Car stereo speaker
3-axis orientation sensor from MicroStrain. May
be dropped due to cost if found unnecessary.
Behringer ECM8000 microphone, intended for
acoustic testing. Very flat response from 15Hz
to 20KHz
2x Audiobuddy 2 channel microphone preamp,
feeding to M-Audio Delta-44 4 channel 96/24 PCI
sound card.
30 cm inter-mic spacing
CPU Currently a ruggedized industrial PC from
littlePC.com
6
Questions
  • Would this kind of platform be helpful to your
    group?
  • Are there additional / unnecessary features?
  • Is 96 KHz / 24 bit useful to you?
  • Microphone spacing?
  • Microphone preamps
  • Need phantom power
  • The one I selected runs off 9V AC ?
  • Rather have it run off a (noisy) DC supply

7
Mote Localization in More Detail
Relative locations of motes more poorly
constrained
  • Inter-mote ranging.. Why not?
  • Additional hardware and software constraints
  • Resource consumption
  • Emitter only is low-cost
  • How important is it?
  • Bi-partite geometry may leave locations of motes
    poorly determined
  • Other constraints
  • Bearing estimates?
  • Mote connectivity?

8
Tripod System in more Detail
After motes in blue region are located, move
tripods to cover green region
  • Grounding the coordinate system
  • Locate one tripod at origin position, define it
    as the origin
  • Will another fixed point be needed?
  • System feedback to user
  • System can ask tripods to be moved to improve
    constraints
  • System indicates when all motes in region are
    located
  • Cover more ground by moving tripods

Origin
9
Experimental Ranging TechniquesLeveraging Four
Channels
  • Bearing estimates
  • Add constraints to multilateration
  • May be helpful to address bi-partite topology
  • Angular inconsistencies across nodes might detect
    obstructed signals
  • Computed based on detected ranges to each
    microphone
  • More sophisticated analysis might correlate mic
    signals

10
Multipath Bearing Estimation
  • Bearing estimates of multipath components?
  • Distribution of incoming paths (angle and
    intensity)
  • Might provide clue about whether path is
    obstructed
  • Cases with LOS should have much stronger direct
    path
  • Deduce location of sender in some cases?
  • Estimation using model of reflectors
Write a Comment
User Comments (0)
About PowerShow.com