Pass4sure 300-135 Study Guide - PowerPoint PPT Presentation

About This Presentation
Title:

Pass4sure 300-135 Study Guide

Description:

One of the best Pass4sure 300-135 Cisco dumps Questions with Answers.Go for this to get 100% pass in your Cisco 300-135 Certification Exam. Hurry up dont waste your time.Join us today for further detail. – PowerPoint PPT presentation

Number of Views:20
Slides: 8
Provided by: Username withheld or not provided

less

Transcript and Presenter's Notes

Title: Pass4sure 300-135 Study Guide


1
Cisco 300-135 exam in just 24 HOURS! REAL EXAM
QUESTIONS ANSWERS Cisco 300-135 Buy Complete
Questions Answers File from http//www.pass4sure
dumps.in/300-135.html 100 Exam Passing
Guarantee Money Back Assurance
2
  • QUESTION 1
  • When troubleshooting an EIGRP connectivity
    problem, you notice that two connected EIGRP
    routers are not becoming EIGRP neighbors. A ping
    between the two routers was successful. What is
    the next thing that should be checked?
  • Verify that the EIGRP hello and hold timers match
    exactly.
  • Verify that EIGRP broadcast packets are not being
    dropped between the two routers with the show ip
    EIGRP peer command.
  • Verify that EIGRP broadcast packets are not being
    dropped between the two routers with the show ip
    EIGRP traffic command.
  • Verify that EIGRP is enabled for the appropriate
    networks on the local and neighboring router.
  • Answer D
  • QUESTION 2
  • Which IPsec mode will encrypt a GRE tunnel to
    provide multiprotocol support and reduced
    overhead?
  • 3DES
  • multipoint GRE
  • tunnel
  • transport
  • Answer D
  • QUESTION 3

3
  • Answer A, B, D
  • QUESTION 4
  • Which statement is true about an IPsec/GRE
    tunnel?
  • The GRE tunnel source and destination addresses
    are specified within the IPsec transform set.
  • An IPsec/GRE tunnel must use IPsec tunnel mode.
  • GRE encapsulation occurs before the IPsec
    encryption process.
  • Crypto map ACL is not needed to match which
    traffic will be protected.
  • Answer C
  • QUESTION 5
  • The implementations group has been using the test
    bed to do a proof-of-concept' that requires
    both Client 1 and Client 2 to access the WEB
    Server at 209.65.200.241. After several changes
    to the network addressing, routing scheme, DHCP
    services, NTP services, and FHRP services, a
    trouble ticket has been operated indicating that
    Client 1 cannot ping the 209.65.200.241 address.
    Use the supported commands to Isolated the cause
    of this fault and answer the following
    questions. On which device is the fault condition
    located?
  • R1
  • R2
  • R3
  • R4
  • DSW1
  • DSW2
  • ASW1 H.ASW2

4
  • QUESTION 6
  • The implementations group has been using the test
    bed to do a proof-of-concept' that requires
    both Client 1 and Client 2 to access the WEB
    Server at 209.65.200.241. After several changes
    to the network addressing, routing scheme, DHCP
    services, NTP services, and FHRP services, a
    trouble ticket has been opened indicating that
    Client 1 cannot ping the 209.65.200.241 address.
    Use the supported commands to isolated the cause
    of this fault and answer the following
    questions. The fault condition is related to
    which technology?
  • NTP
  • Switch-to-Switch Connectivity
  • Access Vlans
  • Port Security
  • VLAN ACL / Port ACL
  • Switch Virtual Interface
  • Answer B
  • QUESTION 7
  • The implementations group has been using the test
    bed to do a proof-of-concept' that requires
    both Client 1 and Client 2 to access the WEB
    Server at 209.65.200.241. After several changes
    to the network addressing, routing scheme, DHCP
    services, NTP services, layer 2 connectivity,
    FHRP services, and device security, a trouble
    ticket has been opened indicating that Client 1
    cannot ping the 209.65.200.241 address. Use the
    supported commands to isolated the cause of this
    fault and answer the following questions. What is
    the solution to the fault condition?
  • R1
  • R2
  • R3
  • R4
  • DSW1
  • DSW2

5
  • ASW1
  • ASW2
  • Answer G
  • QUESTION 8
  • The implementations group has been using the test
    bed to do a proof-of-concept' that requires
    both Client 1 and Client 2 to access the WEB
    Server at 209.65.200.241. After several changes
    to the network addressing, routing scheme, DHCP
    services, NTP services, layer 2 connectivity,
    FHRP services, and device security, a trouble
    ticket has been opened indicating that Client 1
    cannot ping the 209.65.200.241 address. Use the
    supported commands to isolated the cause of
  • this fault and answer condition located?
  • R1
  • R2
  • R3
  • R4
  • DSW1
  • DSW2
  • ASW1
  • ASW2
  • Answer A

the following questions. On which device is
the fault
QUESTION 9 The implementations group has been
using the test bed to do a proof-of-concept'
that requires both Client 1 and Client 2 to
access the WEB Server at 209.65.200.241. After
several changes to the network addressing,
routing scheme, DHCP services, NTP services,
layer 2 connectivity, FHRP services, and device
security, a trouble ticket has been opened
indicating that Client 1 cannot ping the
209.65.200.241 address.
6
  • Use the supported commands to isolated the cause
    of this fault and answer the following
    questions. The fault condition is related to
    which technology?
  • BGP
  • NTP
  • IP NAT
  • IPv4 OSPF Routing
  • IPv4 OSPF Redistribution
  • IPv6 OSPF Routing
  • IPv4 layer 3 security
  • Answer D
  • QUESTION 10
  • The implementations group has been using the test
    bed to do a proof-of-concept' that requires
    both Client 1 and Client 2 to access the WEB
    Server at 209.65.200.241. After several changes
    to the network addressing, routing schemes, DHCP
    services, NTP services, layer 2 connectivity,
    FHRP services, and device security, a trouble
    ticket has been opened indicating that Client 1
    cannot ping the 209.65.200.241 address. Use the
    supported commands to isolated the cause of this
    fault and answer the following questions. On
    which device is the fault condition located?
  • R1
  • R2
  • R3
  • R4
  • DSW1
  • DSW2
  • ASW1

7
  • Buy Complete Questions Answers File from
  • PDF Version Test Engine Software Version
  • 90 Days Free Updates Service
  • Valid for All Countries

http//www.pass4suredumps.in/300-135.html
Write a Comment
User Comments (0)
About PowerShow.com