Refilling Tips of Inkjet Cartridges and HP Refills - Atlantic Inkjet

1
HOW TO REFILL TONER PRINTERS WITH HP REFILLS?
Atlantic Inkjet
2
Material Requirement

• Material Requirement
• Screw driver,
• Tweezer,
• Toner HP Refills or Powder,
• Brush,
• Soft Cloth.

3
Steps Of Refilling Toner Printer
1. First of all find 4 screws and unscrew the
both end of the hp 12 toner cartridge. 2. Open
the drum side cover by just pulling it from drum
gear side. 3. Get out the drum by simply sliding
the drum by side. 4. Remove the magnetic roller
by slightly making gaps and inserting the tweezer
on the other side of the hp toner and not the
Inkjet Cartridges. 5. Remove the magnetic roller
washer by the tweezer.
4
Next Step
6. Open the other end of the cartridge by pulling
it gently until it separated and do not remove
the gears. 7. Then you will find two parts, one
is waste toner part and other is empty toner
part. 8. Get out the tension spring located at
waste toner part. 9. Remove the drum pressure
roller from the waste toner part of the hp 12 a
cartridge. 10. You will see the wiper blade just
below the pressure roller. Unscrew and remove the
wiper blade and clean it by soft cloth. Do not
twist the transparent blade part.
5
Next Step
11. Remove the waste dust with the help of brush
and clean it gently by a soft cloth. Do not
damage the plastic film blade that is stick on
the cartridge. Fix the wiper blade and fasten the
screw gently. 12. Now, clean the drum pressure
roller by soft cloth and check for any dry sticky
dust on the roller. If necessary clean the roller
by a wet cloth. 13. Fix the pressure roller to
its position and empty the tonner unit is any
dust remains. 14. Shake the toner HP Refills
well dust before refilling. Pour the dust by help
of a piece of paper.
6
Next Step
15. Assemble the both unit of the Cartridges
gently and reassure the adjustment with no gaps
remaining on the either sides of the toner
cartridge. Do not use Inkjet Cartridges and make
excess pressure during assembling, simply make
the position it will get its position
softly. 16. Fix the magnetic roller gently.
Locate the spring part of the magnetic roller D
shaped. Match the shape with the cartridge
body. 17. During fixing of the magnetic roller
you have to make slight gap so,that the gear gets
its right position. 18. If necessary use a new
drum for the best result. Place the drum by
gently sliding to the cartridge body. Do not
touch the drum area, hold the drum by its gear.
7
Next Step
19.Tighten all the screws and fix the tension
spring by the help of a tweezer.

• 4981 Irwindale Ave, Suite 200
• Irwindale, California
• 91706, United States
• 626-371-1021

https//store.atlanticinkjet.com/
8
(No Transcript)