Formal Bow Ties For Men And Boys In UAE

1
BOWTIES GENTS
How to Tie a BOW TIES
2
First Step
Measuring the Bow Tie
Lift up your collar Though a bow tie can be tied
with the collar either up or down, youll have a
much easier time seeing what youre doing with
the collar up, so lift it and ensure the top
button of your shirt is buttoned
3
Second Step
Measure your neck Stand up straight and use a
tailors measuring tape to measure your neck
starting from the base of the back of your neck
and ending in the front where your collar sits at
just around your Adams apple.
4
Third Step
Size the bow tie Bow ties are one size fits all,
but they have ways to adjust the length either
with a slider or button holes .
5
Fourth Step
Place the bow tie around your neck.  Like tying a
regular necktie, one end of the bow tie needs to
drape over your chest longer than the other.
Position the bow tie so that one end hangs
roughly 1.5 inches (3.8 cm) lower than the other
end.
6
Fifth Step
Cross the longer end over the shorter end. You
should cross the tie near your neck so that the
loop around your neck is just large enough to
work with but not loose you dont want your bow
dangling in front of your chest. 
7
Sixth Step
Loop the long end under where the two ends
cross. With one hand hold the point where the two
ends cross over the front of your collar. Take
the dangling portion of the longer end and pass
it behind and then up over the point of
intersection.
8
Seventh Step
Fold the dangling end to make a loop.  Lift up
the shorter endwhich is still danglingand fold
it over on itself at the widest part of the bowed
shape . Lift the whole portion and turn it 90
degrees, so it faces horizontal.This will form a
loop that points to the same side as the shoulder
over which the longer end is resting. Hold this
fold together at the skinniest part of the bow
tie, which should be just in front of your Adams
apple.
9
Eighth Step
Drop the longer end over the skinny center of the
bow Take the longer end off your shoulder and
drape it over the skinniest part of the bow
section you created in the last step.
10
Ninth Step
Pinch the bow together in front of the long
end Grab the left and right sides of the
horizontally folded end and pinch them together
in front of the dangling end.The top of the
dangling end will now be held between them.
11
Tenth Step
Feed the middle of the dangling end back through
the knot There will be a small gap behind the bow
portion that you can see while you have it
pinched forward. Fold the draping end of the bow
tie on itself like you did with the short end and
pull the loop from the fold through the hole.It
will now form the back half of the bow.
12
Eleventh Step
Pull at the loops , Thats It . Pulling at the
flat ends of the bow tie will simply untie it
like pulling on the dangling strings of
shoelaces, so make sure you tighten the bow tie
by pulling gently at the looped portions.
13
Following These simple Step ,You can easily Tie
up your Bow Tie. If You are looking to Own Formal
Bow Ties For Men In UAE
14
Thanks For Watching