geyser installation services

1
Geyser Installation Services
2
Description

• The Geyser-R Heat Pump Water Heater must be
  installed in the accordance with Local and
  National codes as well as the installation
  instructions in this manual. Before beginning the
  installation, carefully read the entire manual
  and check the local, state, and national codes
  regarding building, electrical, and plumbing
  installations, or check with your local
  authorities for clarification of these codes.
  Failure to install the Geyser-R in accordance
  with these codes and the installation manual may
  result in property damage, bodily injury or
  death.
• ? Disconnect all power before installing or
  servicing the Geyser-R
• . ? There is a discharge fan located on the
  unit. Extreme caution must be exercised to ensure
  that any foreign objects including fingers and
  hands remain clear of the fan area. ? Do not
  stand, sit or place any objects on or beside the
  unit (clearances are stated in the installation
  manual)
• ? Do not allow children to play on or near the
  unit.
• ? Make sure all power is disconnected and shut
  off before moving the unit.
• ? Cover should not be removed with power on.
• ? Internal components may be HOT. Please allow
  sufficient time for the unit to cool completely
  before touching any internal components.
• ? Ensure that the power receptacle for the
  Geyser-R is rated for 115 V. and at least 15 A.
• ? Ensure that the electrical supply has a
  properly rated fuse or breaker protection rated
  for at least 15 amps. It is suggested to use a
  dedicated outlet.

3
Water Connections

• On the top or side of every water heater tank,
  you'll find water supply connections.
• The water connections allow cold or tepid water
  to enter the tank and hot water to exit the tank.
  
• Corrosion can often occur at water connections
  points due to the joining of two dissimilar
  metals.

• Bradford Whites
  Dielectric Waterway Fittings
• Unique steel-to-plastic construction that
  prevents corrosion.
• Creates a dielectric
• waterway by insulating
• the inside of the metal
• casing, thus inhibiting
• internal corrosion from
• the two adjoined metals.

4
Dip Tube

• The dip tube is designed to direct the incoming
  cold water to the bottom of the heater.
• Without a dip tube the cold water coming into
  heater would just mix with some of the hot water
  at the top of the tank on its way to the outle
• Bradford WhitHydrojet Total Performance System
• Engineered to reducecostly sediment
• buildup in the tank.
• Creates a more thoroughmixing of water,
• reducing thermal
• stratification
• Increases firstdelivery

5
Thank You

• Read more geyser installation services
• Log on to www.Doorstephub.com