200-125 Dumps | Grades4sure

1
CCNA Cisco Certified Network Associate CCNA (v3.0)

• Exam Code 200-125

Get Verified 200-125 Dumps
2
Exam Description
This exam assesses a candidate's knowledge and
skills in relation to the basics of the network,
LAN switching technologies, IPv4 and IPv6 routing
technologies, WAN technologies, infrastructure
services, infrastructure security and
infrastructure management.
https//www.grades4sure.com/200-125-exam-questions
.html
3
Exam Details
Exam Code

200-125
CCNA Routing and Switching
Associated Certifications

90 Minutes (60 - 70 questions)

Duration
Available Languages

English, Japanese
https//www.grades4sure.com/200-125-exam-questions
.html
4
Exam Topics

• 0 Network Fundamentals 15
• 0 LAN Switching Technologies 21
• 0 Routing Technologies 23
• 0 WAN Technologies 10

• 0 Infrastructure Services 10
• 0 Infrastructure Security 11
• 0 Infrastructure Management 10

If you want to cover these topics then download
Grades4sure 200-125 dumps and clear all concepts
of Cisco 200-125 exam syllabus.
https//www.grades4sure.com/200-125-exam-questions
.html
5
Grades4sure 200-125 exam Question
Just These Steps Required To Success The Exam
For Download Cisco 200-125 Practice Test Visit
Us https//www.grades4sure.com/200-125-exam-quest
ions.html
6
Grades4sure 200-125 study material are printable
in PDF and exam engine formats. For best result
Recommended PDF Exam Engine.
https//www.grades4sure.com/200-125-exam-questions
.html
7
https//www.grades4sure.com/200-125-exam-questions
.html
8
Question No 1
Refer to the exhibit.
When running OSPF, what would cause router A not
to form an adjacency with router B? A. The
loopback addresses are on different subnets. B.
The values of the dead timers on the routers are
different. C. Route summarization is enabled on
both routers. D. The process identifier on router
A is different than the process identifier on
router B. Answer B
https//www.grades4sure.com/200-125-exam-questions
.html
9
Question No 2
Refer to the exhibit.
What is the meaning of the output MTU 1500
bytes? A. The maximum number of bytes that can
traverse this interface per second is 1500. B.
The minimum segment size that can traverse this
interface is 1500 bytes. C. The maximum segment
size that can traverse this interface is 1500
bytes. D. The minimum packet size that can
traverse this interface is 1500 bytes. E. The
maximum packet size that can traverse this
interface is 1500 bytes. F. The maximum frame
size that can traverse this interface is 1500
bytes. Answer E
https//www.grades4sure.com/200-125-exam-questions
.html
10
Question No 3
What levels will be trapped if the administrator
executes the command router(config) logging trap
4 (Choose four) A. Emergency B. Notice C.
Alert D. Error E. Warning Answer A,C,D,E
https//www.grades4sure.com/200-125-exam-questions
.html
11
Question No 4
What authentication type is used by SNMPv2? A.
HMAC-MD5 B. HMAC-SHA C. CBC-DES D. community
strings Answer D
https//www.grades4sure.com/200-125-exam-questions
.html
12
Question No 5
Which set of commands is recommended to prevent
the use of a hub in the access layer? A.
switch(config-if)switchport mode trunk
switch(config-if)switchport port-security
maximum 1 B. switch(config-if)switchport mode
trunk switch(config-if)switchport port-security
mac-address 1 C. switch(config-if)switchport
mode access switch(config-if)switchport
port-security maximum 1 D. switch(config-if)switc
hport mode access switch(config-if)switchport
port-security mac-address 1 Answer C
https//www.grades4sure.com/200-125-exam-questions
.html
13
Question No 6
Refer to the exhibit. While you troubleshoot a
connectivity issue to a PC behind R1, you enter
the show access-lists command to generate this
output. Which reason for the problem is most
likely true? A. Thepermit allACL entry on R1 is
inactive. B. The ACL of R1 is misconfigured. C.
Adeny allACL entry is currently active on R1. D.
Animplicitdenyis causing R1 to block network
traffic. Answer D
https//www.grades4sure.com/200-125-exam-questions
.html
14
Question No 7
The command ip route 192.168.100.160
255.255.255.224 192.168.10.2 was issued on a
router. No routing protocols or other static
routes are configured on the router. Which
statement is true about this command? A. The
interface with IP address 192.168.10.2 is on this
router. B. The command sets a gateway of last
resort for the router. C. Packets that are
destined for host 192.168.100.160 will be sent to
192.168.10.2. D. The command creates a static
route for all IP traffic with the source address
192.168.100.160. Answer C
https//www.grades4sure.com/200-125-exam-questions
.html
15
Question No 8
What are three broadband wireless technologies?
(Choose three.) A. WiMax B. satellite
Internet C. municipal Wi-Fi D. site-to-site
VPN E. DSLAM F. CMTS Answer A,B,C
https//www.grades4sure.com/200-125-exam-questions
.html
16
Question No 9
Which configuration can you apply to enable
encapsulation on a subinterface? A. interface
FastEthernet 0/0 encapsulation dot1Q 30 ip
address 10.1.1.30 255.255.255.0 B. interface
FastEthernet 0/0.30 ip address 10.1.1.30
255.255.255.0 C. interface FastEthernet 0/0.30
description subinterface vlan 30 D. interface
FastEthernet 0/0.30 encapsulation dot1Q 30 ip
address 10.1.1.30 255.255.255.0 Answer D
https//www.grades4sure.com/200-125-exam-questions
.html
17
Question No 10
When the copy running-config startup-config
command is issued on a router, where is the
configuration saved? A. Random access memory
(RAM) B. Flash C. Non-volatile random access
memory (NVRAM) D. Read-only memory (ROM) Answer
C
https//www.grades4sure.com/200-125-exam-questions
.html
18
Features of Grades4sure.com
1
Exam Passing Guarantee
Free Updates of Cisco 200-125 Exam
Passing Ratio 98.
Verified Dumps By The IT Specialist.
No Hidden Fee
https//www.grades4sure.com/200-125-exam-questions
.html
19
Thank You!