Reinforcing Bars

1
Gemina International
2
Reinforcing Bars
3
Reinforcing Bars
Rebar is known as a tensioning device because it
holds concrete in a compressed state. Concrete is
a very strong material when it is in compression,
but it has almost no strength where carrying
tensile loads is concerned. To overcome this,
rebar is cast in poured concrete to carry these
loads.
4
Reinforcing Bars
Additionally, the design of the rods typically
includes the deformity (in the form of heavy
ridge patterns) that further support the binding
of the Rebar Exporter, Rebar Manufacturer to the
concrete.
5
Deformation standards are identified by the
following

• The letter or symbol of the producers mill will
  be rolled into the rebar
• The size of the bar is rolled into the rebar and
  appears as a numeral
• The symbol for the type of steel (These are
  limited to S carbon steel, I rail steel, A
  axle steel, W low alloy steel, IR rail
  meeting, SS stainless steel, CS low carbon
  chromium)

6
Historically, rebar has only been in use since
the 1400s, and the use of ferrous steel was
introduced to eliminate the risks of corrosion.
Though it is possible to find other metals or
grades, it is steel Rebar manufacturer, exporters
an Turkey that GEMINA has available. All standard
sizes and grades are in stock and produced in top
quality mills in Turkey, the European Union and
Asia.
7
Website http//www.geminatrade.com/products/rein
forcing-bars/