Calibration Software Services in Bestlabs Singapore (2)

1
Calibrating new equipment With bestlabs Singapore
2

• It cannot be overstressed how essential it's that
  every one new equipment is calibrated before it's
  used, but at regular intervals. this may make
  sure that the machines parameters remain within
  tolerance.
• It's also worthwhile remembering that parameters
  can change over time, thanks to negligent
  maintenance, incorrect use and, of course,
  general wear and tear.

3

• All new BESTLABS SINGAPORE equipment is
  calibrated before dispatch. However, it cannot be
  assumed that new equipment from other test
  machine manufacturers is already calibrated and,
  albeit it's , whether that calibration Services
  Singapore shows that the machine is suitable for
  the testing required.
• While the machines engineering tolerances could
  even be met when it's being manufactured, the
  precise requirements for a specific test method
  won't are applied.

4

• Another situation that commonly arises is that
  the machine supplier won't be fully aware of
  which test methods the laboratory intends to use.
  As a result, the machine may conform to a totally
  different species.
• Because there are many different test methods
  (both national and Calibration Company Singapore)
  which will exist for a given test routine, it
  isn't surprising that a machine acknowledged for
  one particular test method won't conform to the
  requirements of another.
• In line with this, purchasers are recommended to
  request that a full Calibration Services is run
  on any new machines and, if relevant, that they
  meet the requirements of specific test
  procedures.

5
Frequency of calibration

• This depends upon the parameter being measured,
  how often the machine is used , and therefore the
  way critical the measurement is to the appliance
  or product.
• Equipment that's in constant use (or that
  suffers an enormous level of wear and tear and
  tear during its operation) would require
  calibration to need place more frequently than
  more robust items or people who are seldom used.
• By contrast, the dimensions or mass of solid
  metal parts that are not exposed to wear won't be
  need to be re-measured for up to five years after
  the initial calibration.

6
OUR LOCATION

• BESTLABS SINGAPORE PTE LTD10 Admiralty Street,
• 02-90 02-91 North link Building,
• Singapore 757695.
• http//calibration.sg/
• CONTACT
• Phone [phone]