Quick Guide to using your Flowermate Hybrid X

1
Quick Guide to using your Flowermate Hybrid X
2
Charging the Flowermate Hybrid X
It takes around 90-120 minutes for charging the
Hybrid X from Flowermate. You will know when its
ready since the battery icon on the screen will
come up as full. It is advisable you charge it
plugged into the wall as opposed to laptops. You
will maximize the life of the battery if you
dont leave it plugged in for a longer period of
time or overnight.
3
Perform a quick burn-off of the Hybrid X's oven.
Once the battery becomes fully charged, it is
worth performing a quick burn-off of the
Flowermate Hybrid X oven. The burn-off will clear
all leftover residue from within the oven. To
carry it out, turn the dry herb and wax atomizer
by pressing the power button 5 times in rapid
succession. Set the temperature to the maximum by
using the and temperature buttons. Once you
have selected the right temperature, press the
power button for two seconds and the oven will
start heating up.
4
Packing the herb oven with dry herbs/resin/wax
Press the switch on top of the device to open its
lid. You can place the dry herbs in the oven or
on the stainless steep pod. Most vapers prefer
using oven direct but it may be easier to keep
clean if you use capsules. You will want to use
capsules if using wax or resin as they become
sticky! Place the herb into the oven until it is
3/4th full and pack it down using a tool coming
with the device.
5
Packing the herb oven with oil
When vaping soft wax or oils you must always use
proper capsules. If vaping oil place cotton
inside the capsule and add some drops until the
cotton becomes saturated- but ensure to not
overfull as it may damage the oven.
6
Filling the E-Liquid tank of the Flowermate
Hybrid X
To fill the e-liquid tank of the hybrid vape,
unscrew the base of the tank from the chamber and
pre-soak the heating coil with your e-juice.
Proceed to fill the tank from the bottom by
tilting it somewhat, it is important to avoid
getting e-juice into central airflow tube. After
filling the tank, replace its base and check out
for leaks. When you are sure it is saturated,
screw it back into the Flowermate Hybrid X.
7
Getting a "No Atomizer" message?
Getting no atomizer message occurs when the
atomizer base isnt making direct contact with
the coil. In such case, disconnect the tank and
unscrew the base, unscrew the head of the
atomizer from the base, clean inside the atomizer
base with an earbud, reconnect the coil to the
base, making sure the coils gets screwed tightly.
8
Thank You
For more details visit https//flowermate.com/pro
duct/hybridx/