Steps To Vinyl Wrap A Car - Reload Detailing

1
Simple Steps To Vinyl Wrap A Car
Have you finally decided to give your car a
proper make-over using vinyl wraps? If yes, then
let's go through the step-by-step process to
install these vinyl wraps on your car seamlessly.
2
Have A Proper Plan
Step 1
As we all know, nothing big is achieved without a
plan. Before vinyl wrapping your car, this step
is quintessential. If you want to wrap your car
in designed vinyl sheets, make sure that the
design is of high quality and doesnt break or
look distorted when stuck onto a 3D
surface. Also, the higher the quality is the
vinyl, the more it will last. Though the
differences are not detectable to naked eyes in
the beginning, low-quality vinyl wraps will start
fading and bubbling with time. So, if you want
your car vinyl wraps to last long, best to go for
top printed vinyl sheets.
3
Decide Your Work Area
Step 2
Yes, when it comes to vinyl wrapping your car,
the location where you perform the DIY is also
equally important. If youre planning to work
outdoors, wed recommend you reconsider. In
simple words, we need a facility where the
chances of big and small dust particles sticking
to the surface are minimal. Vinyl wraps are
unforgiving, and every small detail within shows.
Moreover, big chunks of dust might even tear the
wrap, eventually allowing water to seep into and
weaken the adhesive.
4
Prepare The Canvas
Step 3
Now, its time to prepare your canvas! Major
problems such as chips, dents, and rust can
impose a problem while vinyl wrapping. If the
wrap sticks to the imperfections, it will be
evidently visible, and if it doesnt, theres a
chance of the area bubbling up and tearing apart.
So, before the installation, make sure that the
paint underneath is intact and the wraps have a
smooth surface to glide over.
5
Remove Any Hindrances
Step 4
Going over small surfaces such as mirrors, door
handles, headlights is doable. But it can add up
your installation time by hours, especially if
youre a first-time DIYer. So, save yourself some
trouble and remove these obstacles beforehand to
ensure a smooth installation.
6
Step 5
Clean The Work Area And Your Car Surface
Sweep or vacuum your work area clean before
beginning the installation. Do not do the
cleaning and installation side by side, as sands
and dust flying around can stick to your car
surface and disturb the installation.
7
Measure And Cut The Vinyl Sheets
Step 6
Measure and measure twice such that the
dimensions are accurate. If it helps, you can
sketch a rough diagram of your car and have all
the measurements written down. When its time to
cut the sheets, remember to cut them a few inches
bigger.
8
Laying The Sheets
Step 7
You might need a few helping hands for this step.
Stretch the sheets a few inches above the area of
installation and remove the backing from the
sheets. Remember to exert equal tension on the
backing to reduce wrinkles.
9
Managing Stuck Air And Wrinkles
Step 8
To manage air bubbles and wrinkles, gently peel
the vinyl off the area, blow some mild heat, no
more than 120 ºF, and apply gentle pressure to
stretch the sheets.
10
Finishing The Wrapping DIY
Step 9
Once all the edges are set, use a heat gun to
activate adhesives on the rest of the vinyl
sheets. Using squeegee and hands to bond the
sheets to the surface and take care of bubbles
safely with a pin, if necessary.
11
Contact US
Reload Detailing Phone NO- 859-630-4179 Email
ID- Reloaddetailing_at_yahoo.com Address- 4448
Kidwell Ln, Fort Wright, KY 41017 Website-
https//reloaddetailing.com/