Install PSPICE 9.1 with Schematics

1
Install PSPICE 9.1 with Schematics

• By Cameron Musgrove
• For
• ENSC 2613

2

• Download setup file from http//ensc2613.okstate.e
  du/91pspstu.exe
• Then double-click on the file to run it.

3

• Change folder location in the top picture (that
  you see upon running the file) to the folder
  location in the picture below.
• Click the Unzip button when the folder path has
  been changed.

4

• The program should extract the files and report
  it was successful. If not, check to be sure you
  have enough available disk space.
• Close the self-extractor window.

5

• Go to the folder with the extracted files
  (C\temp)
• Double-click on setup.exe to start the
  installation.

6

• You will see this dialog box. Press OK to
  continue with installation.
• (I have not problems installing PSPICE with
  antivirus software running. In fact, as I write
  this tutorial I have many programs running. Use
  your own judgment, and what works!)

7

• Click Yes to continue with installation.
• Assuming, of course, you do have administrative
  privileges.

8

• It is essential that you check the box for
  Schematics. Otherwise, the tutorial in the
  back of the book will not apply to you!
• Schematics is the graphical user interface
  program to draw and simulate circuits.
• Select Next to continue.

9

• Choose a destination folder if you wish. Click
  Next to continue.
• It is best to avoid using spaces in filenames
  with any program related to PSPICE, with the
  exception of installing the software to Program
  Files directory. Below this directory, please,
  do not use spaces.

10

• Click Next to continue.

11

• You should see an installation summary similar to
  this one.
• Be sure that Schematics is listed under
  Products to Install
• Click Next to continue.

12

• You should see a screen similar to this one.
• After the progress bar fills, a few other boxes
  will appear while the program continues to
  install itself.

13

• You might get a dialog box like this one.
• It just means that you will not be able to
  double-click your schematic file to open it in
  PSPICE. This is probably a good thing, as your
  other programs are unaffected.
• Click OK to continue.

14

• Uncheck the Release Notes box
• Click Finish to end setup

15

• To Run PSPICE, go to Programs, PSpice Student,
  Schematics.
• Have a lot of fun simulating!