How to install Micro DVR into Removable Type bracket

1
How to install Micro DVR into Removable Type
bracket
2
1. Open the top cover of bracket
There are one screw on top and two screws on rear.
3
2. Open the front door using provided key
4
3. Take out HDD bay from the bracket
There are 2 screws on rear and two screws on
front. Make it like the right picture.
5
4. Take out DVR bay from the bracket
DVR bay
There are 4 screws on bottom as right picture.
6
5. Mount DVR onto DVR bay and open the top cover
of DVR
7
6. Take out Power switch and remove Power In from
DVR
Take out Power Switch This power switch will be
use at the front of bracket.
Remove below power in connector.
8
7. Connect HDD cable Power cable as below
9
8. Close the top cover of DVR
The HDD cable position should be above picture.
10
9. Mount DVR and connect Power switch Power
cable as below
11
10. Mount HDD bay and connect HDD cable as below
12
Inside picture after installed MRX 1004A
DC24VgtDC12V converting Power board
13
Supply DVR power
Supply camera power Max. 500mA per camera
Connect the power supply from bus
Connect Main power Switch
14
Front picture after installed MRX 1004A
15
HDD Case
7.6 cm
13.5 cm
16
HDD Case
1.4 cm
USB2.0 standard port For direct connect to PC
Connector between DVR and removable HDD
Remark No need any HDD cradle to connect it
with PC. It can be use like
external USB2.0 HDD.
17
Accessories 1
Connector for power from BUS
Connector for camera power supply
18
Accessories 2
This two mounts are only for this sample.
These mounts could be use as below picture.
19
Remark Standard packing of mounts will be as
below from the main order.
A-TYPE
B-TYPE