Brazed bent metal coat hanger

1
Brazedbent metalcoat hanger
2
Cut 2 pieces of .5 x .5 metal 28.25 inches long
3
Cut 2 pieces of.5 x .5 metal12 inches long
4
Grind ends smooth, rounding slightly
5
Pin configuration for bending back of coat rack
6
Set metal in diacro bender even with bending pins
7
metal in diacro bender, ready for bending
8
Begin clockwise bend around pins
9
Bends for back completed
10
Stop bends here
11
Back finished with both ends bent to shape. You
need two of these parts
12
Back parts have been sized and bent to 16
between washer locations
13
Pin setup for loop on hanger
14
Set up for bending hanger loop
15
Loop half done
16
Hanger loop complete
17
Pin set up for hanger
18
Hanger bends done
19
Bend clockwise to this point
20
Hanger completeoption 1
21
You can make hangers option 1 into hangers option
2 by using the following directions
22
Line up end o hanger option 1 w/bending pins
23
Bend hanger option 1 to shape of option 2

• Note pin location

24
Completed hanger option 2
25
Washers get brazed into top loops both ends
26
Washer brazed in place
27
Make sure both hangers match shape
28
Hanger is measured 3.5 from end of cross pieces

• Cross pieces must be even on ends

29
Measure 3.5 from end of back
30
Hanger option 1, lines up with top back piece
31
Set hanger option 2 on back to mark
32
Square hanger option 1 with cross pieces
33
Hanger must be square to back
34
Make sure ends of backs line up
35
Set up for brazing option 2
36
SQUARE HANGERS WITH BACK PARTS
37
BRAZE HANGER TO BOTTOM BACK
38
BRAZE 2ND END HANGER TO BOTTOM BACK
39
2ND END DONE
40
SET UP FOR BRAZING HANGERS TO TOP BACK
41
BRAZE HANGERS TO TOP BACK
42
CLEAN METAL FOR PAINTING