Floral Design Bud Vase Construction

1
Floral DesignBud Vase Construction

• Step by Step Directions

Original Power Point Created by Karen
Nolcox Modified by Georgia Agricultural Education
Curriculum Office September 2005
2
Step 1 Select Materials

• 1 long-stem rose or 1 carnation (any color)
• 2-3 stems leather leaf ferns
• 1 stem babys breath or other filler flower
• Other Foliage (Optional)
• 1 ½ yards 3 ribbon
• Wire
• Floral Tape
• Bud Vase
• Card and Pick

3
Step 2 Fill Vase with Water

• Fill bud vase with preservative water to within 2
  inches of the top.

4
Step 3 Remove Lower Foliage

• Remove all foliage and thorns that will be under
  water to prevent rot and ethylene gas.

5
Step 4 Cut the Flower Stem

• Cut the flower stem to a height of 1 ½ to 2 times
  the height of the vase.

6
Step 5 Wire the Rose

• Use 22 gauge wire
• Use the straight-wire method
• Gradually wrap wire around the stem, being
  careful not to break off leaves
• Do NOT tape

7
Step 6 Insert the Flower into the Vase

• Place the rose in the vase.
• Turn the most desirable side outward.

8
Step 7 Add Foliage

• Select 2 pieces of leather leaf fern that are
  slightly taller than the flower.
• Place these behind the flower.
• They should be triangular in appearance, and may
  bend slightly away from the flowers.

9
Step 8 Add Babys Breath

• Add a sprig of babys breath.
• Babys breath should surround the rose inside of
  the foliage.

10
Step 9 Make and Insert a Bow

• Make a bow using 3 ribbon
• Bow color should match flower
• Bow should have four to five loops
• Attach bow to a pick
• Insert the pick into the front of the vase
  
  

11
Step 10 Refrigerate

• Place the completed vase in the cooler or
  refrigerator to help preserve the flowers.

12
Step 11 Clean up the Work Area

• Put away all materials
• Sweep and clean the work area

13
Congratulations!You Did a Great Job