Configuring Linksys Wireless Ethernet Bridge

1
Configuring Linksys Wireless Ethernet Bridge

• Prof. Yousif
• _at_
• Valencia Community College

2
Wireless Ethernet Bridge

• Home Page
• Default Address 192.168.1.225

3
Enable LAC5
4
The default SSID is linksys unless a beacon is
heard with a different SSID
5
Basic Configuration
Default PW is admin
admin
Change to WB, where refers to your PC number
6
Basic Configuration
Auto sensed from the beacons broadcasted by the
Cisco AP
7
Basic Configuration
Must enter GW Address
8
No Security Config. Later
9
Confirm!
10
Web Access Open your browser and type the
address you used during configuration 10.0.0.3
Make sure that you Ethernet Card is configured to
be on the same network
11
Confirm Association
IP Add. Of PC
MAC Add. Of W. Bridge
12
Check the Firmware Version
Old
13
Upgrade the WB Firmware
14
Download the firmware
Capture
15
Install firmware Upgrade
Make Sure that you enter the correct IP address
of the WB and the correct password
16
Site Survey
17
Supports WEP Only,Doesnt Support WPA