TOLERANCE DESIGN AND TOLERANCING

1
LECTURE 11

• TOLERANCE DESIGN AND TOLERANCING

2
Tolerance Design and Tolerancing
3
Functional Limits and the Societal Loss
4
Functional Limits and the Societal Loss (Cont.)
5
Functional Limits and the Societal Loss (Cont.)
6
Functional Limits and the Societal Loss (Cont.)
7
Functional Limits and the Societal Loss (Cont.)
8
Determinations of Tolerances
9
Tolerance Design for the Nominal-the-Best (N Type)
10
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
11
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
12
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
13
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
14
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
15
Tolerance Design for the Nominal-the-Best (N
Type) (Cont.)
16
Tolerance Design for the Larger-the-Better
Characteristics (L Type)
17
Tolerance Design for the Larger-the-Better
Characteristics (L Type) (Cont.)
18
Tolerance Design for the Larger-the-Better
Characteristics (L Type) (Cont.)
19
Tolerance Design for the Larger-the-Better
Characteristics (L Type) (Cont.)
20
Tolerance Design for the Smaller-the-Better
Characteristics (S Type)
21
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)

• Compare the quality levels of the two machines,
  based on 20 units produced by each machine under
  the same conditions of control, with the
  roundness measured in µm. The measurements are
  given in Table 3.2.

22
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
23
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
24
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
25
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
26
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
27
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
28
Tolerance Design for the Smaller-the-Better
Characteristics (S Type) (Cont.)
29
Tolerance Allocation for Multiple Components
30
Tolerance Allocation for Multiple Components
(Cont.)
31
Tolerance Allocation for Multiple Components
(Cont.)
32
Tolerance Allocation for Multiple Components
(Cont.)
33
Tolerance Allocation for Multiple Components
(Cont.)
34
Tolerance Allocation for Multiple Components
(Cont.)
35
Tolerance Allocation for Multiple Components
(Cont.)
36
Tolerance Allocation for Multiple Components
(Cont.)
37
Tolerance Allocation for Multiple Components
(Cont.)
38
Tolerance Allocation for Multiple Components
(Cont.)
39
Tolerance Allocation for Multiple Components
(Cont.)
40
Tolerance Allocation for Multiple Components
(Cont.)
41
Tolerance Allocation for Multiple Components
(Cont.)
42
Nonlinear Tolerancing
43
Nonlinear Tolerancing (Cont.)
44
Nonlinear Tolerancing (Cont.)