Title: Introduction to Optoelectronics Optical communication (2)
1Introduction to OptoelectronicsOptical
communication (2)
2Lasers
- Spontaneous emission and stimulated emission
- Application of Lasers
- Classification of lasers according to the way of
pumping - Laser diodes
- What is semiconductor?
- p/n junction diode
- Light emitting diode and laser diode
3What is Laser?
- Spontaneous and stimulated emission
- Different pumping methods
- Characteristics of laser light
4Spontaneous and stimulated emission
- Spontaneous emissionLight emission by relaxation
from the excited state to the ground state - stimulated emissionLight emission due to optical
transition forced by optical stimulation - This phenomenon is the laserlight amplification
by stimulated emission of radiation
5Optical transition
- Transition occurs from the ground state ?1? to
the excited state ?2? with the probability of P12
by the perturbation of the electric field of
light This is an optical absorption. - The excited state ?2? relaxes to the ground state
?1? spontaneously with a light emission to
achieve thermal equilibrium
Energy
?2?
Spontaneous emission
?1?
6Stimulated emission
Energy
?2?
- Transition from the excited state ?2? to the
ground state ?1? occurs by the stimulation of the
electric field of incident light with the
transition probability of P21(P12), leading to
emission of a photon. This process is called
stimulated emission. - The number of photons is doubled since first
photon is not absorbed.
E
p12
Stimulated emission
?1?
7Emission is masked by absorption under normal
condition
- Under normal condition stimulated emission cannot
be observed since absorption occurs at the same
probability as emission (P12P21), and the
population N1 at ?1? dominates N2 at ?2? due to
Maxwell-Boltzmann distribution. Therefore,
N2P21ltN1P12
N2
?2?
p21
Stimulated emission
?1?
N1
N2
?2?
p12
Optical absorption
?1?
N1
8Maxwell-Boltzmann distribution
- The population at the excited state ?2? located
at ?E above the ground state ?1? is expressed by
a formula exp(-?E/kT)
9population inversion for lasing
- In order to obtain net emission (N2P21gtN1P12),
N2, the population of the state ?2 ? should
exceed N1, the population of the state ?1?. - This is called population inversion, or negative
temperature, since the distribution feature
behaves as if the temperature were negative.
10Characteristics of laser
- Oscillator and amplifier of light wave
- Wave-packets share the same phase leading to
- Coherence two different lasers can make
interference fringes - Directivity laser beam can go straight for a
long distance - Monochromaticity laser wavelength is pure with
narrow width - High energy density laser can heat a substance
by focusing - Ultra short pulse laser pulse duration can be
reduced as short as femtosecond (10-15 s) - Bose condensation ? quantum state appearing
macroscopically
11Application of lasers
- Optical Communications
- Optical Storages
- Laser Printers
- Diplays
- Laser Processing
- Medical Treatments
12Optical fiber communication
13Optical Storages
14Laser Printers
http//web.canon.jp/technology/detail/lbp/laser_un
it/index.html
15Laser Show
16Laser Processing
Web site of Fujitsu
17Medical Treatment
18Classification of lasersaccording to the way of
pumping
- Gas lasers
- eg., He-Ne, He-Cd, Ar, CO2,
- pump an excited state in the electronic
structure of gas ions or molecules by discharge - Solid state lasers
- eg., YAGNd, Al2O3Ti, Al2O3Cr(ruby)
- pump an excited state of luminescent center
(impurity atom) by optical excitation - Laser diodes (Semiconductor lasers)
- eg., GaAlAs, InGaN
- high density injection of electrons and holes to
active layer of semiconductor through pn-junction
19Gas laserHeNe laser
Showa Optronics Ltd. http//www.soc-ltd.co.jp/inde
x.html
20HeNe laser, how it works
- He atoms become excited by an impact excitation
through collision - The ground state is 1S (1s2 L0, S0) and the
excited states are 1S (1s1?2s1 ? L0, S0) and
3S (1s1?2s1 ? L0, S1) - The energy is transferred to Ne atoms through
collision. - Ne has ten electrons in the ground state 1S0 with
1s2 2s2 2p4 configuration, and possesses a lot of
complex excited states
http//www.mgkk.com/products/pdf/02_4_HeNe/024_213
.pdf
21HeNe laser different wavelengths
He
- 3.391 ?m mid IR
- 1.523 ?m near IR
- 632.8 nm red ?
- 612 nm orange?
- 594 nm yellow??
- 543.5 nm green ????
Ne
23S
21S
1S
22Gas laserAr-ion laser
- Blue458nm
- Blue488nm
- Blue-Green 514nm
23Application of gas laserAr ion laser
- Illumination (Laser show)
- Photoluminescence Excitation Source
24Gas laserCO2 laser
- 10.6?m
- Purpose
- manufacturing
- Medical surgery
- Remote sensing
25Solid state laserYAG laser YVO4laser
- YAGNd
- 1.06?m
- Micro fabrication
- Pumping source for SHG
http//www.fesys.co.jp/sougou/seihin/fa/laser/fal3
000.html
26Solid state laserTitanium sapphire laser
Ti-sapphire laser in Sato lab.
27Solid state laserRuby laser
- Al2O3Cr3
- Synthetic ruby single crystal
- Pumped by strong Xe lamp
- Emission wavelengths 694.3nm
- Ethalon is used to select a wavelength of interest
Ruby laser
Ruby rod
28LD (laser diode)
- Laser diode is a semiconductor device which
undergoes stimulated emission by recombination of
injected carriers (electrons and holes), the
concentration being far greater than that in the
thermal equilibrium.
29What is semiconductor?
- Semiconductors possess electrical conductivity
between metals and insulators
30Temperature dependence of electrical conductivity
in metals and semiconductors
- Resistivity of metals increases with temperature
due to electron scattering by phonon - Resistivity of semiconductors decreases
drastically with temperature due to increase in
carrier concentration
31Conductivity, carrier concentration, mobility
- Relation between conductivity ? and carrier
concentration n and mobility ? - ? ne?
- Resistivity? and conductivity? is related by
?1/? - Mobility is average velocity vcm/s introduced
by electric field EV/cm , expressed by equation
v? E
32Periodic table and semiconductors
IIB IIIB IV V VI
B C N O
Al Si P S
Zn Ga Ge As Se
Cd In Sn Sb Te
Hg Tl Pb Bi Po
IV (Si, Ge) III-V (GaAs, GaN, InP, InSb) II-VI
(CdS, CdTe, ZnS, ZnSe)
I-VII (CuCl, CuI) I-III-VI2 (CuAlS2,CuInSe2) II-IV
-V2 (CdGeAs2, ZnSiP2)
33Crystal structures of semiconductors
- Si. Ge diamond structure
- III-V, II-VI zincblende structure
- I-III-VI2, II-IV-V2 chalcopyrite structure
Diamond structure
34Energy band structure for explanation of metals,
semiconductors and insulators
35Concept of Energy BandTwo approaches
- Approximation from free electron
- Hartree-Fock approximation
- Electron is treated as plane waves with
wavenumber k - Energy E(?k)2/2m (parabolic band)
- Approximation from isolated atoms
- Heitler-London approximation
- Linear combination of s, p, d wavefunctions
36Band gap of silicon
covalent bonding
isolated atom
conduction band
3p
Energy gap
Energy
Antionding orbitals
3s
valence band
Bonding orbitals
lattice constant of Si
Si-Si distance
Schematic illustration of variation of electronic
states in silicon with Si-Si distance
37Band gap and optical absorption spectrum
Direct gap InSb, InP, GaAs
Indirect gap Ge, Si, GaP
38Band gap and optical absorption edge
- When photon energy Eh? is less than Eg, valence
electrons cannot reach conduction band and light
is transmited. - When photon energy Eh? reaches Eg, optical
absorption starts.
conduction band
Eg
h?gtEg
h?
valence band
39Color of transmitted light and band gap
40Semiconductor pn junction
Energy
N type
P type
space charge potential
Carrier diffusion takes place when p and n
semiconductors are contacted
- - - -
space charge potential
41LED, how it works?
hole
electron
- Forward bias to pn junction diode
- electron is injected to p-type region
- hole is injected to n-type region
- Electrons and holes recombine at the boundary
region - Energy difference is converted to photon energy
electron
-
electron drift
energy gap or band gap
recombination
light emission
hole drift
42Semiconductors for LD
- Optical communication1.5?m GaInAsSb, InGaAsP
- CD780nm GaAs
- DVD650nm GaAlAs MQW
- DVR405nm InGaN MQW
43Double hetero structure
- Electrons, holes and photons are confined in thin
active layer by using the hetro-junction structure
http//www.ece.concordia.ca/i_statei/vlsi-opt/
44Invention of DH structure (1)
- Herbert Kroemer and Zhores Alferov suggested in
1963 that the concentration of electrons, holes
and photons would become much higher if they were
confined to a thin semiconductor layer between
two others - a double heterojunction. - Despite a lack of the most advanced equipment,
Alferov and his co-workers in Leningrad (now St.
Petersburg) managed to produce a laser that
effectively operated continuously and that did
not require troublesome cooling. - This was in May 1970, a few weeks earlier than
their American competitors. - from Nobel Prize Presentation Speech in Physics
2000
45Invention of DH structure (2)
- In 1970, Hayashi and Panish at Bell Labs and
Alferov in Russia obtained continuous operation
at room temperature using double heterojunction
lasers consisting of a thin layer of GaAs
sandwiched between two layers of AlxGa1-xAs. This
design achieved better performance by confining
both the injected carriers (by the band-gap
discontinuity) and emitted photons (by the
refractive-index discontinuity). - The double-heterojunction concept has been
modified and improved over the years, but the
central idea of confining both the carriers and
photons by heterojunctions is the fundamental
philosophy used in all semiconductor lasers. - from Physics and the communications industry W.
F. Brinkman and D. V. Lang Bell Laboratories,
Lucent Technologies, Murray Hill, New Jersey 07974
http//www.bellsystemmemorial.com/pdf/physics_com.
pdf