Can you name the Tools ?

1
Can you name the Tools ?
2
S-10 Drum Brake
3
Removal of return spring
4
1, Adjuster lever
1
5
Guide plate 2
2
6
Remove Hold down Springs, The short one goes with
adjuster lever
7
Remove adjuster lever and return spring , note
pivot bushing 3
3
8
Note position of parking brake strut rod and anti
rattle spring 4
4
9
Note curve and wide end on strut
Strut for parking brake with the anti rattle
spring
10
Note alignment of parking brake lever
11
Remove hold down from short shoe
12
Remove shoesas aunit careful of the adjuster
spring 5
5
13
Remove adjuster 6 with out stretching of spring
5
5
6
14
A clean layout will help you with assembly
15
Removal of parking brake lever from cable
16
Inspect wheel cylinder for leaks and free
movement of pistons
17
Note wear on backing plate and lube with proper
brake grease
18
Reassemble Clean, No grease or dirt on hands or
brake friction material!
19
Place holdown pin in pivot bushing to hold
adjuster lever in place
20
With care not to stretch spring attach primary
shoe with adjuster spring
21
Attach primary shoe with care not to stretch
adjuster spring
22
(No Transcript)
23
Hold Down spring
24
Hold pin from rear and turn in with a half twist
of tool to lock Spring
25
Narrow slot goes towards primary shoe
26
Tool is not needed to place the adjuster rod
27
Replace return springs with care not to over
stretch
28
Insert adjuster return spring with small end up.
Note position of adjuster 7
7
29
Almost perfect!
30
Replace primary return spring and note guide
plate clearance
31
Inspect what you expect!!!
32
Use a safety Set tool to pre adjust shoes
33
Set measurement to drum first
34
Replace drum and check for noise and shoe
adjustment
35
Thanks to the Morning Zoo Crew Leaders, Andy and
Tim