Title:
1 ELECTRICAL SAFETY
2ELECTRICAL INSPECTION THE FOLLOWING EXAMPLES
ARE INTENDED TO ASSIST THE BUILDING MANGER IN
DETERMINING THE DEGREE OF COMPLIANCE, WTHIN
HIS/HER OPERATIONS AND ACTIVITIES AND THE
ASSOCIATED ELECTRICAL HAZARDS IN THEIR
BUILDINGS. ALL DESIGN AND INSTALLATION OF
EQUIPMENT AND FACILITES SHALL BE IN ACCORDANCE
WITH APPLICABLE NEC, OSHA, DOE, AND SLAC POLICIES
AND PROCEDURES.
3INSPECT WORK AREA FOR ELECTRICAL HAZARDS DAILY,
SHOULD INCLUDE, BUT NOT LIMITED TO THE
FOLLOWING EXTENSION CORDS FRAYED OR
WORN
4 GROUND PIN INPLACE (MISSING)
CONTINUOUS LENGTHS NO
DAISY-CHAINING
5 ACCEPTABLE
6 UNACCEPTABLE
7 PROTECT FROM DAMAGE INCLUDING THAT
CAUSED BY FOOT OR VEHICLE TRAFFIC
8ELECTRICAL PANELS
NO OBSTRUTION WITHIN 36 INCHES IS THERE
SUFFICIENT CLEARANCE AROUND ELECTRICAL EQUIPMENT?
9 GFCI (GROUND FAULT CIRCUIT INTERRUPTER)
WITHIN SIX FEET OF SINKS AND EXTERIOR DOORS ON
METAL-SURFACED WORKBENCHES ON OUTDOOR
RECEPTACLES
10 OUTDOOR WEATHERPROOF COVER (MISSING)
11 TEST MONTHLY IF PRACTICAL
12PROTECTIVE COVERS GUARDING OF ENERGIZED
PARTS TO PREVENT ACCIDENTAL CONTACT OVER
POWER PANELS, JUNCTION BOXES, AND UNUSED HOLES.
13ELECTRICAL PANEL DIRECTORIES IN PLACE AND
ACCURATE AND POWER CABINETS AND BREAKERS PROPERLY
LABELED
14 ENERGIZED WORK ALERT THE
OCCUPANTS OF THE PLANNED WORK WARNING SIGNS
AND BARRICADES PPE (PERSONAL PROTECTIVE
EQUIPMENT)
15LOCKOUT TAGOUT DEVICE ATTACHED TO
PREVENT OPERATION
16 OTHER HAZARDS/VIOLATIONS RACEWAY
CANNOT BE USED TO SUPPORT LOW VOLTAGE OR LIMITED
ENERGY CABLES GROUNDING BONDING OF
CABLE TRAYS
17 OVERLOADED POWER STRIP METAL LADDER
IN AREA WHERE EXPOSED ENERGIZED PARTS ARE
PRESENT
18MAINTENANCE REPAIRS UNQUALIFIED PERSONS
SHALL NOT TAMPER WITH BUILDING ELECTRICAL WIRING
19ELECTRICAL SAFETY IS EVERYONES RESPONSIBILITY
! REDUCING ELIMINATING EXPOSURE TO
ELECTRICAL HAZARDS REQUIRES YOUR CONSTANT
ATTENTION