Title: HOLT CASTLE
1HOLT CASTLE
- aka death of a fieldwork site, a tale of burial
by shotcrete - JLC summer 2006.
2WJEC Geology GL3
- Key Idea 4
- Engineering activities
- Problems of ground instability
- Cuttings rock strength, stable and unstable
patterns of geological structures
3The site
- Only 15 minutes from my College, a public access
site (so no permission needed), no specialist
footwear required - A RIGS site with a notice board about the geology
and history of the area - Red sandstone, showing cross bedding, and pebbles
carried by flash floods (Bunter Pebble Beds) - Holt Coddington Fault (only surface outcrop), and
some small scale faulting - Shows 3D outcrop due to extraction of rock
4Noticeboard
5(No Transcript)
6The site
- Also the site of a SAM - Scheduled Ancient
Monument Holt Castle, 10 years ago fenced off
with metal fence to deny access, although all
the local families have their scars from falling
off the castle - Romans originally extracted red sandstone from
here, castle built in 1600s and many local
buildings are also made of the sandstone
7June 2005
- A couple of years previously the site was given
an explanation board (Local Authority) - The site had also been given some fences,
although these were not to prevent access to the
rock faces
8June 2005.
9Beautiful cross bedding
palaeocurrent
10Cross bedding
11Cross bedding, here damaged by rock bolts
12June 2005 overgrown with nettles, cross bedding
just visible
13Holt-Coddington Fault, Tear fault, 2.5 mile
displacement
14June 2005
- Site overgrown with nettles
- This is due to the fences not allowing the Local
Authority lawn mower access close up to the rock
faces, and also less human and animal trampling
to keep them down
15Nettles are 1.45m high!
16Ancient castle, walls overhanging, very
overgrown with vegetation
Faulted block
Cross bedded area
Fenced off
Viewpoint under shady tree!
June 2006, no nettles, but loads of machinery!!!
17castle
Faulted block
Work already underway Faces bolted to
secure Before shotcrete applied
18Castle, large overhang!
Use of metal pillars to support Before metal
cage and shotcrete applied
High nettles, not mowed by council due to fencing
Helpful, onsite workers!
June 2006 castle wall being shored up
19Close up of overhanging castle wall
20Overhang has been in this state for more than 20
years. Ivy coverage has not been maintained and
this has weakened the structure.
21June 2006
- the site workers say
- CADW have found some money and decided the castle
was unsafe and are going to carry out remedial
work - CADW are the Welsh Assembly Government Historic
Environment division, its from the Welsh word
to keep
22Remedial work
- stability of overhanging corner (and another wall
of the castle), to be given metal reinforced
concrete cage to support it - Rock bolting of weaker faces, and shotcrete to be
applied
23Consultation?
- NEWRIGS had prepared a report on the geology of
the site for CADW, 2 years previous to this, but
had not been consulted since - In discussion with the on-site CADW archaeologist
CADW will protect the SAM at all costs,
including covering the rock faces with concrete
24ROCK BOLTING
Cherry picker cage used during drilling for rock
bolts
25ROCK BOLTING
Galvanised bolts Average 2.7m depth Takes about
5 minutes to drill Screw pattern to attach
nuts These are not STRESSED anchors They are
not under tension
26ROCK BOLTING
Rock bolt right through the cross bedding!
27ROCK BOLTING
Rock bolts glued in place Finger pointing to
where the glue has oozed out
28Rock bolts
- To provide support for a metal framework to be
attached before the shotcrete is sprayed on
Metal frame/cage
29Metal cage is created by using wire ties
Metal pad to spread force over wider area
30Shotcrete
- Sprayed on concrete
- Ordinary concrete delivered by wagon
Local concrete delivery person!
31Concrete fed through hopper, SA160 added to
control set time, and mix sent to sprayer
Control panel for speed and mix variations
Sheeting to minimise damage to grass
Tester samples, to test set rate
32- SA160 added to make concrete set
- Aim for setting time of 10-15 minutes
- But once a few layers have been sprayed it is
left for 24 hours to cure - Operator works from a cherry picker and has full
control of both cherry picker and shotcrete hose
33Sprayed over the site, Much reliance on eye and
experience technique of operator
Hose 1 compressed air From an on site compressor
Hose 2 larger, concrete feed concrete mixed with
SA160 to shorten the setting time to approx 15
minutes
34Hose only operating at ¼ speed otherwise too much
force and the guy would be thrown out of the
cherry picker!
Blue sheeting Covers up areas not to be sprayed
35After 3 sprayings of shotcrete Metal
framework thickening up and being covered
Blue sheeting To stop overspray
36Shot crete final coat
- Final coat will have a colour added
- But CADW are adamant that this should NOT exactly
match the rock faces - So it can be seen that this has been added and is
not natural!
37June 2006, during
38Note concrete colour to blend but not an exact
match Soil has been back filled
August 2006, after
39June 2006 castle wall being shored up
40July 2006, rock bolted, and framework applied,
first layers of shotcrete
41August 2006 after shotcrete completed
42I am very grateful to the guys on site from
SprayCon and Colin Jones (Rock Engineering) Ltd
for their patience in answering my questions!
43(No Transcript)
44(No Transcript)