Remix%20clay%20in%20a%20walker%20pug%20mill.

1
Remix clay in a walker pug mill.
2
The purpose of wedging is to get rid of the air
pockets trapped in the clay.
3
(No Transcript)
4
Roll the clay with a rolling pin between two
strips of wooden guides.
5
Place the paper templates on the sheet of clay
and cut-out the parts.
6
Use a mold to make a pinched form work.
7
A cardboard template is held against the bowls
side to check and guide its progress.
8
With one hand thrust inside and the other hand
pressing from the outside.
9
A cylinder is formed in two halves because clay
shrinks, a complete cylinder would be difficult
to remove from the tile.
10
A well-wedged clay ball is pressed on the center
of an electrical wheel head.
11
DRINKING MUG A cutaway shows the wall of the
drinking mug.
12
DRINKING MUG Throwing curved forms.
13
COIL POT In the coil-building method, the wall of
the pot is gradually built up a base by laying
coils of clay one on the top of another. Score
the joinging parts, apply slip over the scored
area and join together under pressure.
14
CERAMIC RELIEF