Concrete Countertop

1
Welcome To Werkmaster

• http//www.werkmaster.com/

2
Concrete Countertop

• Houses are made up of good solid concrete
  materials, so that it can last very long. But
  once the house is made, its required to be
  getting the perfect finishing touch, so that the
  shine would be lingered.
• Now we have a solution for Concrete Countertop
  with the help of various qualities of stones such
  as, granite, limestone, marble, slate,
  travertine, stone tiles, etc.

3
Floor machines
Scarab Great in small spaces Works on
concrete Edges and polishes
Termite XT Plug into any 110 outlet Runs with or
without handle Wet or dry grinding
Viper XT 220 V (runs 110 using 220 adapter) Edges
to 1/8 of wall Perfect for refinishing and
maintaining
4
Tooling Placement on Pads
Bow Tie Configuration
The bow tie configuration is used for grinding on
softer surfaces with metal bond tooling when
minimal point pressure is required.This
configuration is also used with resin bond
tooling for polishing. This greater contact area
allows for higher pad speeds (rpm) to achieve a
high gloss finish.
5
Tripod Configuration
The tripod assembly (standard configuration) is
used on concrete surfaces when a polished look is
the end result or desired finish.
6
Opposing Configuration
The opposing configuration is used when maximum
point pressure is required. Use this setting to
increase the cutting capability of your tooling.
This setting is recommended for coating removal,
prepping for cementitious overlays, epoxy
coatings and when a CSP rating is required.
7
Full Plate Configuration
The full plate configuration is used to remove
lipage and in areas where bridging is required.
8
For More Information you Can Visit-http//www.werk
master.com

• End

Thank You