CERTAIN WAYS TO RAISE THE EFFICIENCY OF YOUR BOILERS

1
CERTAIN WAYS TO RAISE THE EFFICIENCY OF YOUR
BOILERS
2
Index

• Reduction of air intake
• How about installing an Economizer
• Reduction in blow down
• Switch to cheaper fuel
• Work Of Air Preheater
• Types of air preheaters

3
(No Transcript)
4

• Today, not only the industry, but also living
  spaces have increased the demand for steam
  boilers, especially in terms of heating and power
  generation.
• Several well-known companies propose to reduce
  the blow-off from boilers, to prevent the boiler
  or air preheater tubes from corrosion and
  scaling.
• This article examines quite a few hints that can
  help improve the efficiency of your boiler.

5
Reduction of air intake

• Did you know that a boiler is due to excessive
  air consumption? When less air is needed, the
  extra is automatically heated and released into
  the atmosphere. Setting the fuel air can be
  somewhat difficult but effective.
• As it automatically leads to Carbon Black Deposit
  inside the chamber and even over the boiler
  tubes.

6
How about installing an Economizer

• If you do not find enough heat transfer surfaces,
  the economizer pipes can contain boiler water or
  feed water, as the temperature of the exhaust
  gases can be quite high.
• Thus, these Economizer tubes filled with safety
  valves can prevent the boiler from overpressure
  damage.

7

• Reduction in blow down
• It is about to control to the minimum and since
  the Steam is generated from the evaporation of
  water, the remaining are becoming more
  concentrated.
• Switch to cheaper fuel
• Natural gas and heating oil generally cost the
  same in comparison. So they switch to cheaper
  fuels, they can provide large amount of benefits.

8

• Apart from all these, did you know that heat loss
  from the skin of the boiler can be used back to
  burning? Yes, seamless pipe manufacturer advice
  by preheating the intake air in the furnace
  becomes more efficient.
• http//www.maniks.com/manufacturer/air-preheater/

9

• So it is certainly feasible ways to increase the
  efficiency of your boiler. For more information
  and updates on boilers, pre-heated tubes,
  hydraulic tubes, keep an eye on this room.
• Work Of Air Preheater
• The operating mode of the air preheater in
  counter-current, co-current flow, co-current flow
  counter-current or cross-counter-current or
  cross-co-current flow. The design of the device
  depends on the media and temperature conditions
  of the application. For small construction finned
  tubes are suitable to arrange in a small space a
  lot of heating surface. Dust or other particles,
  so that deposits are expected, smooth tubes are
  preferably used, which are less prone to deposits
  and are easier to clean.

10

• In most applications, an air preheater is carried
  out in several stages, i.e. it consists of
  several individual heat exchangers connected in
  series on the air side.
• They heat the air passing through them with
  wasted heat energy, therefore, air Preheaters are
  used in various areas such as boilers, industrial
  furnace units and hot air ventilation systems.
  The design of an air preheater depends on the
  application.

11

• Types of air preheaters
• There are two basic types Of air preheaters
• Rec recuperative or tubular typert
• To regenerate or feed, give water
• Let's discuss one by one shortly
• Visit us
• http//www.maniks.com