Deceleration Mechanics: Knee Injury Prevention - PowerPoint PPT Presentation

1 / 30
About This Presentation
Title:

Deceleration Mechanics: Knee Injury Prevention

Description:

If I don't see it, my athletes go right back to body weight only until they get it right. ... Try to lose as little speed and momentum as possible when turning. ... – PowerPoint PPT presentation

Number of Views:44
Avg rating:3.0/5.0
Slides: 31
Provided by: auea
Category:

less

Transcript and Presenter's Notes

Title: Deceleration Mechanics: Knee Injury Prevention


1
Deceleration Mechanics Knee Injury Prevention
  • Jason Riddell MS, CSCS, USAW
  • Head Strength Conditioning Coach
  • American University

2
The Stoppie, Nose Wheelie or Endo
  • Not the kind of Deceleration Mechanics I was
    talking about but cool none the less!!!
  • No, I dont do this on my motorcycle because it
    is dangerous! Shhhhhhh that is what I tell my
    fiancé!

3
Deceleration Mechanics
  • The ability of an athlete to decelerate their
    body weight with proper biomechanics, then use
    that potential energy and translate it back into
    kinetic energy efficiently accelerating out of a
    jump or turn.
  • Go G-men!!!!!!! I miss Tiki already!

4
Good Mechanics Efficient Change of Direction
(COD)
  • One of the best ever when comes to COD.

5
Bad Mechanics Inefficiency and Possible Injury
  • Commonly, the athlete runs, suddenly stops, and
    then turns, thereby causing a deceleration of the
    lower limb, a forced hyperextension of the knee,
    or a forced tibial rotation, resulting in injury
    to the ACL (3).

6
Sports with the highest occurrence of ACL
injuries
  • FEMALE
  • Gymnastics
  • Soccer
  • Basketball
  • Field Hockey
  • Volleyball
  • Lacrosse
  • Softball
  • MALE
  • Football
  • Wrestling

7
Women are 2 to 8 times more likely to have an ACL
injury than men
  • Intrinsic factors
  • hormonal influences
  • intercondylar notch width
  • joint laxity
  • limb alignment
  • muscle strength
  • neuromuscular activation
  • ligament size
  • Extrinsic factors
  • excessive shoe-surface interface friction
  • sports activity
  • training/conditioning level
  • equipment

8
What factors are in your control as strength
conditioning coaches?
  • lower limb alignment
  • muscle strength
  • neuromuscular activation
  • training/conditioning level
  • More on this later

9
What typically happens with poor mechanics?
  • Typical Scenario
  • An athlete jumps and they land on the balls of
    their feet and end up with their knees out over
    their toes, then jump back up or turn rapidly.
    This lends to the majority of the work
    concentrated on the quads and not letting their
    hamstrings, gluteus and hips take the majority of
    the impact force.
  • In simplest terms they dont sit back when
    landing, and that leads to big problems down the
    road.

10
Knee Anatomy
11
Knee Injury Biomechanics
  • . It is the synergistic relationship between the
    ACL and the hamstrings that activates to decrease
    the shear forces at the knee during pivoting and
    jumping motions (5).
  • In contrast, the quadriceps acts
    antagonistically to the ACL, encouraging forward
    displacement of the tibia relative to the femur.
    The contraction force produced by the quadriceps
    can produce forces in excess of what the ligament
    can handle, predisposing a person to ligament
    tensile failure (1).

12
Knee Injury Biomechanics (visual)
13
2 Major Problems
  • Posterior Kinetic Chain Strength Deficiencies
  • Poor Deceleration Mechanics
  • By addressing these problems we can lower the
    injury rate and keep your athletes on the field
    and out of the athletic training room. In doing
    so, you make yourself invaluable to your sport
    coaches and look like a damn genius to your AD!
    We all know that nothing but good can come of
    that!
  • Lets come back to those factors mentioned
    earlier that we can control.

14
1) Lower Limb Alignment
  • Can be worked on every time you squat, dead,
    lunge, clean, snatch or jerk.
  • Remember that the key is to tell your athletes to
    let your hips, hamstrings and glutes do the work.
    Which joint can hold more weight, your hip or
    knee?
  • Make sure that during squats they have proper
    foot placement and on the concentric portion
    there is no valgus stress on the knee.
  • Cues Insteps off, Spread the floor, Push
    your feet out the side of your shoes, Drive
    through the heel.

15
Tom Platzs Legs
16
1) Lower Limb Alignment
  • With lunges, step-ups, Bulgarian split squats or
    any other unilateral movement the key is to watch
    the knee angle.
  • To be safe I am always saying I want a 90 degree
    angle at the back of the knee with the top of the
    thigh parallel in the bottom. If I dont see it,
    my athletes go right back to body weight only
    until they get it right.
  • With the Olympic lifts the key is to watch the
    catch in whatever lift you might be performing.
    They must catch everything with their heels down
    and their feet the proper width or you are
    setting them up for problems.

17
1) Lower Limb Alignment
  • The primary goal of Olympic lifting is to
    increase rate of force development and power
    output not coordination.
  • Coordination is a nice by-product but not the
    primary reason for using them.
  • If your athletes cant do full cleans and
    snatches correctly then take them back to
    explosive pulls and they will still make
    tremendous progress.

18
2) Muscular Strength
  • Posterior chain (lower)- Hamstrings, Gluteus,
    Spinal Erectors.
  • Ronnie Coleman is pharmaceutically enhanced but
    jacked and strong none the less!!!

19
2) Muscular Strength
  • The show muscles are in the front and the go
    muscles are in the back! Jason Beaulieu Head
    Strength Conditioning Coach at U of Delaware.
  • DLs, Glute/Hams, GMs, RDLs and Rev Hypers.
  • Iso-Dumbell and Barbell RDLs and Iso Hamstring
    bridges for time. Stabilizer work

20
3) Neuromuscular Activation
  • Bouncing not Sticking
  • During natural movements, the primary
    requirement for a proper motion pattern is not to
    resist the external force and decrease the bodys
    kinetic energy but to increase the potential for
    the ensuing takeoff (Zatsiorsky, 158.)
  • When it comes to jumping and landing you want
    your athletes to focus on landing soft and
    making as little sound as possible.
  • During soft landing by experienced athletes,
    only 0.5 of the bodys kinetic energy is spent
    to deform body tissues (bone, cartilage, spine).
    During a stiff landing, the deformation energy
    amounts to 75 of the bodys mechanical energy.
    The difference is 150 fold! (Zatsiorsky, 178)

21
3) Neuromuscular ActivationProper
Jumping/Landing Mechanics
  • Use box jumps for practicing soft landings before
    incorporating traditional plyometrics.
  • Set yourself down on the box and absorb the
    impact by sitting back and letting the
    hamstrings/posterior chain do the work.
  • The position that you jump in, is the position
    you land in.
  • The less noise made on impact the better the
    jump.

22
3) Neuromuscular ActivationProper Turning
Mechanics
  • Short Shuttle/5-10-5/Pro Agility Procedures
  • Athlete begins in a 3 point stance, facing timer,
    with hand on start line and one foot on each side
    of the start line.
  • Athlete starts after being instructed "You may
    go."
  • Run directly to the right 5 yards and touch line
    with right hand.
  • Reverse direction and run directly to the left
    for 10 yards and touch line with left hand.
  • Reverse direction again and run 5 yards through
    the start/finish line.
  • Each athlete performs the short shuttle run
    twice, once to the left and once to the right.

23
3) Neuromuscular ActivationProper Turning
Mechanics
  • 3 Cone Drill Procedures
  • Athlete begins in 3 point stance with hand on
    start'/finish line.
  • Run forward 5 yards and touch top line with right
    hand.
  • Turn back and touch start/finish line with right
    hand.
  • Turn back again and run around top of second
    cone.
  • Weave underneath and around third cone.
  • Run around outside of second cone back through
    start/finish line.
  • Each athlete performs the 3 cone drill twice.
  • Both times are recorded and the best time is used
    for scoring purposes.

24
3) Neuromuscular ActivationTurning Mechanics
Keys
  • If an athlete can turn quickly and change
    direction without dissipating a lot of energy
    they tend to be successful on the field.
  • Turns are all about fluidity mentally picture
    smooth, flowing movements. SmoothFast,
    ChoppySlow
  • Try to lose as little speed and momentum as
    possible when turning.
  • Reducing the risk of knee injury is best
    accomplished by having the athlete get use to
    firing the hamstrings first and not the
    quadriceps to decelerate themselves.
  • This is accomplished by touching the ground with
    legs extended and feet plantar-flexed, and
    immediately after ground contact, avoid a stiff
    landing by flexing the knees and lowering their
    center of gravity (Zatsiorsky, 178).
  • Once again, you must decelerate by lowering the
    center of gravity by dropping the hips in the
    turn.

25
4) Training/Conditioning Level
  • Its easy to stop by landing on your toes when
    fatigue begins to set in.
  • Athletes will go to the old, easy default setting
    if they are not conditioned to use the proper
    mechanics all the time.
  • You as a coach must stress proper mechanics all
    the time and especially when your athletes are
    tired.

26
4) Training/Conditioning Level
  • Jumping/Landing Mechanics
  • Variations of the repetition method.
  • Using a light weight for sets of 30, 40 and 50 in
    all forms of the squat or deadlift are not easy
    but elicit the ability to fire the proper motor
    pattern repeatedly.
  • Remember you are looking for the athlete to
    perform these actions without conscious thought
    and acquire muscle memory.
  • You are only limited by your imagination.

27
4) Training/Conditioning Level
  • Turning Mechanics (COD)
  • Continuous pattern agilities.
  • Examples- Snake, zig-zag, wheel patterns and
    shuttles.
  • The key is to stress proper turning mechanics
    even when fatigue starts to take hold.
  • The bonus to these types of patterns is energy
    system development. Continuous pattern running
    closely simulates most court and field sports
    metabolic demands as compared to straight ahead
    speed and distance runs.

28
Summary
  • I feel that as strength professionals if we can
    focus a little more on limb alignment, muscular
    strength, neuromuscular activation and
    conditioning this will help alleviate the rampant
    problem of knee/ACL injuries we see in athletics
    today.

29
Summary
  • We all know that it isnt completely unavoidable
    and injuries will occur but by reducing injury
    rates and decreasing recovery times we will make
    a stronger, more durable, more productive athlete
    for the future.

30
References
  • 1) Huston, L.J., and E.M. Wojtys. Neuromuscular
    performance characteristics in elite female
    athletes. Am. J. Sports Med. 24(4)427-435. 1996.
  • 2) Ireland, M.L. Anterior cruciate ligament
    injury in female athletes Epidemiology. J.
    Athletic Training. 34(2)150-154. 1999.
  • 3) Loudon, J.K., W. Jenkins, and K.L. Loudon. The
    relationship between static posture and ACL
    injury in female athletes. J. Sports Phys. Ther.
    24(2)91-97. 1996.
  • 4) Pettineo, S.J., K. Jestes and M. Lehr. Female
    ACL injury prevention with a functional
    integration exercise model. Strength
    Conditioning Journal. 26(1)28-33. 2004.
  • 5) Rosene, J.M., and T.D. Fogarty. Anterior
    tibial translation in college athletes with
    normal ACL integrity. J. Athletic Training.
    34(2)93-98. 1999.
  • 6) Zatsiorsky, V.M., Science and Practice of
    Strength Training. Human Kinetics, Champaign, IL.
    1995.
  • (VISUAL) All photos are courtesy of Google Images
    or T-Nation.
Write a Comment
User Comments (0)
About PowerShow.com