BANNER AND STAND INSTRUCTIONS

1
BANNER AND STAND INSTRUCTIONS

• Remove one end of each plastic tube. Remove the
  strip of plastic with d/s tape on it. Peel off
  the protection strip and apply one strip to the
  very top of the banner and the other to the very
  bottom of the banner. It must line up with the
  very bottom and very top edge of the banner.

2. Now insert the end of the banner with the
attached plastic strip into each pole ensuring
the banner slides through the slit on both poles.
Insert
Top
Flag
Fixed
Bottom
4. Finished stand
3. Slide the bottom locator onto the bottom tube
ensuring its the correct way round. Now insert
the plastic ends back onto the poles and make the
frame. Fix the bottom bracket into the locator
space on the bottom tube. Insert frame pole into
top locator as seen on the diagram. Then join the
two in the middle and connect final frame pole
into bottom locator space.