Electrostatic Sensing and Actuation - PowerPoint PPT Presentation

1 / 12
About This Presentation
Title:

Electrostatic Sensing and Actuation

Description:

Electrostatics Review Parallel Plate Capacitor Equation, ... Motion sensed my monitoring capacitance change Capacitance change is non-linear with d Use as an ... – PowerPoint PPT presentation

Number of Views:558
Avg rating:3.0/5.0
Slides: 13
Provided by: SamaraFi
Category:

less

Transcript and Presenter's Notes

Title: Electrostatic Sensing and Actuation


1
Electrostatic Sensing and Actuation
  • EE485A Lecture
  • 10 September 2009

2
Electrostatics Review
  • Parallel Plate Capacitor Equation, again
  • Use as a sensor
  • Motion sensed my monitoring capacitance change
  • Capacitance change is non-linear with d
  • Use as an actuator
  • Voltage applied to induce force
  • Pull-in occurs when voltage exceeds pull-in limit
  • Only motion from 2/3 gap to full gap can be
    controlled
  • Larger range of motion if you control A instead
    of d

3
Interdigitated Capacitors
movable plate
x0
l0
t thickness normal to image ( )
w
w
fixed plate
n fingers (here n 8)
4
What they really look like
http//www.cchem.berkeley.edu/rmgrp/about.html
5
3 Types of motion to consider
Longitudinal (most common)
Out of Plane
Transverse
6
Longitudinal Sensing
keff
x0
l0y
l0 initial overlap distance y distance from
rest
Linear!
Capacitance Sensitivity (Change in Capacitance
for a Change in y)
7
Longitudinal Actuation
Fmech
keff
Felec
x0
l0y
Force is constant as y changes!
No Pull-In! Can control over longer range.
Force balance yields displacement vs. voltage
relationship
8
Exercise
keff
x0
l0y
  • For structure shown above, x0 1 um, l0 100
    um, n 8, t 10 um
  • Determine the capacitance sensitivity to
    longitudinal motion.
  • What is the capacitance change associated with 10
    um of deflection?
  • If the movable electrode were attached to a 1 ug
    proof mass, determine the effective spring
    constant necessary to cause a 10 um deflection in
    the presence of a 100g acceleration.

9
Exercise continued
  • If this same structure (minus the proof mass) was
    then used for actuation, what voltage would be
    required to move the structure 10 um?
  • Determine dimensions for the support arms that
    are consistent with your desired spring constant.

10
Out-of-Plane Motion
z
11
Transverse Motion
  • Usually not intentionally used
  • Transverse actuators exhibit pull-in
  • Comb drive supports carefully designed to prevent
    transverse motion.

12
Look carefully at the suspensions
http//www.cchem.berkeley.edu/rmgrp/about.html
Write a Comment
User Comments (0)
About PowerShow.com