Title: Gauss
1Chapter 24
2Electric Flux
- Electric flux is the product of the magnitude of
the electric field and the surface area, A,
perpendicular to the field - FE EA
3Electric Flux
- The electric flux is proportional to the number
of electric field lines penetrating some surface - The field lines may make some angle ? with the
perpendicular to the surface - Then
- FE EA cos ?
- The flux is a maximum (zero) when the surface is
perpendicular (parallel) to the field
4Electric Flux
- If the field varies over the surface, F EA cos
? is valid for only a small element of the area - In the more general case, look at a small area
element - In general, this becomes
5Electric Flux
- The surface integral means the integral must be
evaluated over the surface in question - The value of the flux depends both on the field
pattern and on the surface - SI units N.m2/C
6Electric Flux, Closed Surface
- For a closed surface, by convention, the A
vectors are perpendicular to the surface at each
point and point outward - (1) ? lt 90o, F gt 0
- (2) ? 90o, F 0
- (3) 180o gt ? gt 90o, F lt 0
7Electric Flux, Closed Surface
- The net flux through the surface is proportional
to the number of lines leaving the surface minus
the number entering the surface
8Electric Flux, Closed Surface
- Example flux through a cube
- The field lines pass perpendicularly through two
surfaces and are parallel to the other four
surfaces - Side 1 F E l2
- Side 2 F E l2
- For the other sides, F 0
- Therefore, Ftotal 0
9Chapter 24Problem 5
- A pyramid with horizontal square base, 6.00 m on
each side, and a height of 4.00 m is placed in a
vertical electric field of 52.0 N/C. Calculate
the total electric flux through the pyramids
four slanted surfaces.
10Gauss Law
- Gauss Law electric flux through any closed
surface is proportional to the net charge Q
inside the surface - eo 8.85 x 10-12 C2/Nm2 permittivity of free
space - The area in F is an imaginary Gaussian surface
(does not have to coincide with the surface of a
physical object)
11Gauss Law
- A positive point charge q is located at the
center of a sphere of radius r - The magnitude of the electric field everywhere on
the surface of the sphere is E keq / r2 - Asphere 4pr2
12Gauss Law
- Gaussian surfaces of various shapes can surround
the charge (only S1 is spherical) - The electric flux is proportional to the number
of electric field lines penetrating these
surfaces, and this number is the same - Thus the net flux through any closed surface
surrounding a point charge q is given by q/eo and
is independent of the shape of the surface
13Gauss Law
- If the charge is outside the closed surface of an
arbitrary shape, then any field line entering the
surface leaves at another point - Thus the electric flux through a closed surface
that surrounds no charge is zero
14Gauss Law
- Since the electric field due to many charges is
the vector sum of the electric fields produced by
the individual charges, the flux through any
closed surface can be expressed as - Although Gausss law can, in theory, be solved to
find for any charge configuration, in
practice it is limited to symmetric situations - One should choose a Gaussian surface over which
the surface integral can be simplified and the
electric field determined
15Field Due to a Spherically Symmetric Charge
Distribution
16Field Due to a Spherically Symmetric Charge
Distribution
- Inside the sphere, E varies linearly with r (E ?
0 as r ? 0) - The field outside the sphere is equivalent to
that of a point charge located at the center of
the sphere
17Chapter 24Problem 18
- A solid sphere of radius 40.0 cm has a total
positive charge of 26.0 1µC uniformly distributed
throughout its volume. Calculate the magnitude of
the electric field (a) 0 cm, (b) 10.0 cm, (c)
40.0 cm, and (d) 60.0 cm from the center of the
sphere.
18Electric Field of a Charged Thin Spherical Shell
- The calculation of the field outside the shell is
identical to that of a point charge - The electric field inside the shell is zero
19Field Due to a Plane of Charge
- The uniform field must be perpendicular to the
sheet and directed either toward or away from the
sheet - Use a cylindrical Gaussian surface
- The flux through the ends is EA and there is no
field through the curved part of the surface - Surface charge density s Q / A
20Conductors in Electrostatic Equilibrium
- When no net motion of charge occurs within a
conductor, the conductor is said to be in
electrostatic equilibrium - An isolated conductor has the following
properties - Property 1 The electric field is zero everywhere
inside the conducting material - If this were not true there were an electric
field inside the conductor, the free charge there
would move and there would be a flow of charge
the conductor would not be in equilibrium
21Conductors in Electrostatic Equilibrium
- When no net motion of charge occurs within a
conductor, the conductor is said to be in
electrostatic equilibrium - An isolated conductor has the following
properties - Property 2 Any excess charge on an isolated
conductor resides entirely on its surface - The electric field (and thus the flux) inside is
zero whereas the Gaussian surface can be as close
to the actual surface as desired, thus there can
be no charge inside the surface and any net
charge must reside on the surface
22Conductors in Electrostatic Equilibrium
- When no net motion of charge occurs within a
conductor, the conductor is said to be in
electrostatic equilibrium - An isolated conductor has the following
properties - Property 3 The electric field just outside a
charged conductor is perpendicular to the surface
and has a magnitude of s/eo - If this was not true, the component along the
surface would cause the charge to move no
equilibrium
23Conductors in Electrostatic Equilibrium
- When no net motion of charge occurs within a
conductor, the conductor is said to be in
electrostatic equilibrium - An isolated conductor has the following
properties - Property 4 On an irregularly shaped conductor,
the charge accumulates at locations where the
radius of curvature of the surface is smallest - Proof see Chapter 25
24Answers to Even Numbered Problems Chapter 24
Problem 64 For r lt a ?/2??0r radially
outward. For a lt r lt b ? ?? (r2?a2)/2??0r
radially outward. For r gt b ? ??
(b2?a2)/2??0r radially outward.