Title: ED%20103:%20splinting%20basics
1ED 103 splinting basics
- Thao M Nguyen, MD
- Daniel A Hirsh, MD
- Pediatric Emergency Medicine
- Emory University
- Childrens Healthcare of Atlanta
2Objectives
- Indications Contraindications
- Basic Principles
- Common Mistakes
- Prepare patient/parent
- Step-by-step instructions
- Complications
- Discharge Instructions
3Indications
- Temporary immobilization
- Protection
- Pain control
4Contraindications
- Compartment syndrome
- Need for open reduction
- Skin at high risk for infection
5Basic Principles
- Temporary
- Non-circumferential
- Non-weight bearing
- Protect the skin
- Pad bony prominences
- Place a dry splint
6Common Mistakes
- Placement of a Circumferential splint
- Placement a Wet splint
- Placement of a Tight Splint
- Not allowing time for the fiberglass to
adequately harden
7Patient/Parent Expectations
- Placement should not hurt
- Most injuries feel significantly better with
splinting alone - Splint material will get warm when it hardens
- Should be snug, not tight
- Fingers toes shouldnt tingle or turn deep
purple
8Step 1 Choose your splints
9Choosing the splint typesupper extremities
- Volar
- Distal radius/ ulna wrist fx
- Sugar Tong
- Distal radius/ ulna wrist fx
- Long Arm
- Elbow forearm injuries
-
- Fleisher, 2006 -
10Choosing the splint typesupper extremities
- Ulnar Gutter
- Boxers fx and uncomplicated 4th 5th phalangeal
fx - Radial Gutter
- 2nd 3rd MCP or phalangeal fx
- Fleisher, 2006 -
11Choosing the splint typesupper extremities
- Thumb Spica
- Nonrotated, nonangulated, nonarticular fx of the
thumb MCP or phalanx gamekeepers thumb
scaphoid (navicular fx) - Buddy Tape
- Fleisher, 2006 -
12Choosing the splint typelower extremities
- Posterior leg
- Foot, ankle distal fibula fx
- Ankle sprains
- Stirrup
- Foot, ankle distal tibia/fibula fx
- Cadillac Splint
- Fleisher, 2006 -
13Step 2 Gather all of your supplies
14(No Transcript)
15Splinting Material
16Stockinette
17Cotton Wadding Cast Padding
18Ace wrap
19Shears
20Step 3 Protect the skin
21Apply stockinette to extremity Extend it past
the proximal and distal ends of where the splint
will end
22Cut out any areas that bunch up that could damage
the skin
23Create thumb hole
24Protect bony prominences
25Cut splint material to proper size
26Protect the skin by creating 1.5 cm border of
cotton by cutting the fiberglass
27Step 4 Activate the Fiberglass
28- Approximate initial hardening times
- Ambient Humidity 15 min
- Cold Water 5 min
- Hot Water 2 min
29Hot water will cause the fiberglass to harden
very quickly
30Cold water
31Keep padding as dry as possible
32Protect the skin. If cotton padding is wet, dry
it.
33Some fiberglass material comes with a thick
padded side and a thin side. Protect the skin.
Always place the thick-side to the skin-side.
34Step 5 Apply the Splint
35Wrap the splint in placenot too loose or too
tight. Protect the skin. Do not apply pressure
with finger tips, use a curved palm.
36(No Transcript)
37Allow time for the fiberglass to cure
38Step 6 Check splint placement
- Make sure patient has normal sensation distal to
splint - Make sure there is normal capillary refill after
splint placement - Make sure the splint does not cause any pain
39Splint Complications
40Discharge Instructions
- Protect the skin. Keep splint dry
- If extremities become tingly or blue, re-wrap the
bandage - Dont allow weight bearing on the splint
- If splint hurts, or there is increasing pain,
TAKE THE SPLINT OFF! Seek medical attention
41Case 1
12 yo female s/p bike accident, fell and landed
on wrists
42Case 2
3 yo male fell while running and landed on leg
43Case 2
44Case 3
16 yo female with left wrist injury 6 wks ago.
Extremity was splinted w/o reduction unable to
F/U with orthopedics
45Suggested Reading
- Fleisher, GR. Textbook of Pediatric Emergency
Medicine, 5th ed, 2006