Firmware Upgrading

1
Firmware Upgrading

• With UCM05 and Comfigurator

2
Firmware Upgrading

• Why Upgrade Firmware?
• To fix bugs
• To add new features
• UCM05 is required to upgrade Comfort II Flash
  versions (ie min 5.100). UCM 5.174 min is
  recommended. UCM 5.147 is min version able to
  upgrade UCM, Slaves and MPU01. UCM5.156 able to
  upgrade Comfort
• Comfort II, Slaves, UCMs can be upgraded for
  firmware gt 5.100

3
Upgrading for Firmware lt 5.100

• For Comfort II and Slave lt 5.100, use MPU plug in
  to upgrade to Flashable. Once MPU is plugged in,
  it can be upgraded.

4
Upgrading Firmware

• Connect Programming Cable with 2 ends (6 way and
  2 way) to UCM doing the programming. The other
  end with 6 way is connected to the Module being
  upgraded
• Shunt PP2 header to enable firmware upgrade

5
Upgrading Firmware

• UCM to Module to be programmed

6
Upgrading Firmware

• Upgrading UCMs You need a UCM05 to upgrade a
  UCM05.
• Upgrading UCMs and Slaves. The module being
  upgraded should not be connected to Comfort
• Upgrading Comfort. If UCM05 is upgrading its own
  Comfort, after programming cable is connected,
  Comfort does not work, and keypads will start
  beeping. Disconnect siren and keypads if too
  noisy.

7
Upgrading Firmware

• Firmware (.cbf files) can be downloaded from
  www.comfortforums.com/upgrades.html
• Comfigurator gt Menu Transfer gt Firmware Upgrade
• Browse and select the .cbf file
• Only the same firmware type is allowed to be
  upgraded, eg Ultra II to Ultra II, UCM/CBUS to
  UCM/CBUS etc.
• Transfer starts and takes 30 seconds to several
  minutes depending on the file. See Progress bar
• After upgrading is completed, remove programming
  cable, remove PP2 and Reset Comfort
• If any errors occur during upgrade, repeat the
  process