Corporate Design PowerPoint-Basis-Templates

1
Synco livingTrain the TrainerACSAugust
2007
2
ACSOperation
Naturally, Synco 900 can also be operated with
the ACS via the OCI700 (service connector at the
central apartment unit) or via the OZW7xx
(KNX-TP1 connection facility at the central
apartment unit).
KNX-TP1 connection facility(rear of the unit)
Service connector
From the ACS perspective, the central apartment
unit can be identified. The RF components are
contained on the central apartment units device
list.
A central apartment unit requires 8 ACS credits.
3
ACSOperation

• All data points can be operated via ACS
  (analogous to Synco 700), with the following
  exceptions
• Bus power supply on / off
• Event time programs (lights, scenes, switching
  groups).
• Phase programs only (absence simulation, DHW
  time switch)
• RF connections (device list, disconnecting,
  deleting, ..)
• Resetting to the supply state
• Data backup / data restoration
• The basic configuration parameters can only be
  changed under Parameter settings and not via the
  Operating Instructions.
• Reason
• Basic configuration parameters must be written as
  an entire block. Then, the device makes a new
  start (analogous to Synco 700).

4
ACSOperation

• Before the ACS can access the central apartment
  unit via the OCI700, the bus power supply must be
  switched on (analogous to Synco 700)
• Commissioning gt Bus communication gt Basic
  settings gt Bus power supply gt On
• The central apartment unit is supplied with bus
  power supply On.

Software ACS7
OCI700