Assembly Drawings

1
Assembly Drawings

• Open a new drawing.
• Standard.iam

2
Adding the Base

• On the left side, click Place Component
• Select your base part in the window and hit open
• Your part should be on screen. Unless you need
  more than one base part, hit Escape.

3
Adding the Ruler

• On the left side, click Place Component
• Select your ruler part in the window and hit open
• Click on the screen to place your part then hit
  Escape.

4
Adding the Rivets

• On the left side, click Place Component
• Select your rivet part in the window and hit open
• Click on the screen to place four parts then hit
  Escape.

5
Joining the Ruler and the Base

• On the left side, click Constraint.
• Click on the face of the ruler where the numbers
  would be.
• Rotate the part so you can see the face inside
  the U in the base that it should be mated to.
• Click on the mating face.
• Click OK.
• Repeat for the bottom face of the ruler and the
  bottom of the groove.

6
Joining the Ruler and the Base

• On the left side, click Constraint.
• In the constraint pallet click Flush in the
  solution section.
• Click on the face of the ruler that is flush with
  the side of the base.
• Click on the flush face.
• Click OK.

7
Checking the Alignment

• Rotate the part to check and see if the hole line
  up.
• If they do not line up, delete the ruler and
  start again.
• The ruler might have been upside down or you may
  need to double check you hole dimensions.

8
Joining the Rivets and the Base

• On the left side, click Constraint.
• Click on the rivet when you get the line through
  the center of the part.
• Go to the hole and click when you see a line
  through the center of the part.
• Click OK.
• Repeat for the other three rivets.

9
Joining the Rivets and the Base

• On the left side, click Constraint.
• In the constraint pallet click Flush in the
  solution section.
• Click on the flat face of the rivet.
• Click on the face of the base that should be
  flush with the flat of the rivet.
• Click OK.
• Repeat for the other three rivets.

10
Congratulations!

• Spin it around and take a look.
• Youre done assembling your part!
• Now you just need to do the print page.
• Make sure you include a section drawing to show
  the rivet details!

11
(No Transcript)